Thomashilfen Hercules Prime R129 Gebrauchsanweisung Seite 52

Instructions for Use – Hercules Prime R129
8.12 Chest clip
Loosen the upper ends of the lap belts from the plastic adjusters. Fit the belt con-
nector onto these belt ends. (Fig. 42) Then reattach the lap belts to the plastic
adjusters. Please note that the belt connector must be fitted underneath the belt
adjusters.
Tip: First completely assemble the chest clip on one side before you loosen the second side.
8.13 Second belt guide, top
A second upper belt guide (Fig. 52) can be fitted for flexible use on different car
seats. The vehicle's 3-point safety belt can be used on the right or left side of the car
seat without having to change the upper belt guide first. For more information on
mounting, see "Adjustment options – belt guide, top".
8.14 Seatfix adapter
Note: Prerequisite for the use of the Seatfix adapter is an existing ISOFIX equipment
of the vehicle. This must be checked before purchase!
The Seatfix adapter is pushed into the holder under the seat plate from behind. (Fig. 43)
Loosely screw the 2 enclosed screws (1 on each side) into the holder so that the
Seatfix adapter can still be moved. (Fig. 44)
Determine the required position of the Seatfix adapter: To do this, place the seat in
the vehicle and insert the Seatfix connectors (with yellow trigger) into the vehicle's
Isofix anchors. Check that the connectors are securely locked in place by pulling. The
backrest of the Hercules Prime must have as much contact with the backrest of the
vehicle as possible. Mark the desired position at the transition between the Seatfix
adapter and the seat plate.
Now loosen the Seatfix connectors and remove the Hercules Prime from the vehicle.
Secure the Seatfix adapter in the marked position with the 2 screws.
52
2025-11