ZAMEL exta life ROP-22 Bedienungsanleitung Seite 36

DELETING (UNPAIRING) ROP-22 FROM EXTA LFE SYSTEM
Each registered ROP-22 receiver can be deleted from the system. Deleting means 'unpairing' a
receiver from a controller.
CAUTION: In case of ROP-22 receiver, there is no possibility to delete (unpair) only one
channel (channel-1 or channel-2). By deleting one out of the two channels, the whole
receiver is deleted from the controller (the
system).
In order to delete a receiver from the EXTA LIFE
system, the following steps must be carried out:
1. Activate the application and enter the De-
vice screen.
2. Select the Receivers tab, next select the
"Delete" option from a particular receiver's
menu.
3. After deletion, a receiver is automatically
removed from the list of paired receivers.
SWITCHING ON / SWITCHING OFF PAIRING (BROADCAST OFF)
Switching off pairing (broadcast) is recommended, if a receiver operates in the EXTA LIFE system
without a controller (e.g. only with radio transmitters). Switching off pairing causes a receiver is
not visible in the search process carried out by means of a controller. The above protects against
taking over control of a receiver by unauthorised users. This situation does not take place in case
a receiver has been previously paired with a controller. In such a case, it is not visible for other con-
trollers in the search process of receivers. Summarising, in order to protect correctly your system,
the following must be carried out:
1. If there is no controller in the EXTA LIFE system – switch off pairing (Broadcast OFF) in all receiv-
ers.
2. If there is a controller in the EXTA LIFE system – pair each receiver with the controller.
Switching off pairing is a reversible process. It means, if the EXTA LIFE controller is installed in
the system, pairing function must be switched on, so that receivers can be found in this system.
SWITCHING OFF PAIRING (BROADCAST OFF)
In order to switch off pairing the following must be carried out:
1. Disconnect power supply from the receiver.
2. Press the PROG. push-button on a receiver.
3. While the PROG. push-button is pressed, switch on power supply.
4. Keep the PROG. push-button pressed for about 5 seconds.
5. When STATUS LED starts flashing orange release the PROG. push-button.
6. After the above steps were carried out, pairing is switched off.
SWITCHING ON PAIRING (BROADCAST ON)
In order to activate pairing, it is necessary to reset the receiver to default settings (see Deleting the
whole memory of a receiver).
CAUTION: As a result of the above, all data (push-buttons, times) entered to a receiver's
memory are deleted. They must be added again. The easiest way to do it is by means of the
EXTA LIFE mobile application, and just after the EXTA LIFE controller has been installed.
 