Operation Modes - Zamel Exta Life Rop-22 Bedienungsanleitung

OPERATION MODES

Switch on / switch off mode
• In the switch on / switch off mode two push-buttons of a transmitter are used. One push-button
always realises the "switch on" function and the second one the "switch off" function.
CAUTION! This mode is used to control a larger number of receivers by means of one
transmitter.
Bistable mode
• In the bistable mode only one push-button of a transmitter is used to control a receiver. The
same push-button realises the "switch on" and "switch off" function. Output control is realised
as a cyclical change of one mode by subsequent pressing the transmitter's button. The bistable
mode allows for an independent control of a larger number of receivers by means of one trans-
mitter. For example, by means of 4 push-button remote control P-457/4, an independent control
of 4 circuits is possible.
CAUTION! It is not recommended that one push-button in a bistable mode is assigned to
more than one receiver. It can have output mode jitter effect during control.
Monostable mode
• In the monostable mode, only one push-button of a transmitter is used to control a receiver.
• A receiver's output is switched on as long as the transmitter's push-button is pressed.
Time mode
• In time mode only one push-button of a transmitter is used to control a receiver.
• A receiver's output is switched on after a transmitter's push-button is pressed, and it switches
off automatically after the adjusted time is over. Pressing a transmitter's push-button during time
measurement causes the receiver's output is switched off earlier (system without time retrigger).
The switching on time is programmed in the range from 1 sec. to 18 hrs. In case of ROP-22, it is
possible to adjust an independent time for each push-button programmed in time mode, for local
inputs and for control by means of an application.
Switch on mode
• This mode is available only by means of switches connected to IN1/IN2 inputs. In this mode, it
is only possible to switch on a receiver's output.
Switch off mode
• This mode is available only by means of switches connected to IN1/IN2 inputs. In this mode, it
is only possible to switch off a receiver's output.
Operation
mode
Switch on/switch off mode
Bistable mode
Monostable mode
Time mode
Switch on mode
Switch off mode
In case of EXTA LIFE radio transmitters, the operation mode is carried out by adding transmitter's
push-buttons to a receiver. In other cases, the operation mode is configured by means of the
EXTA LIFE application.
EXTA LIFE EXTA LIFE
transmitters application
+
+
+
+
-
-
Monostable
+ (default)
- + (default)
-
+
-
-
Bistable
switch switch
+
+
+
+
+
+
+
-
+
+
+