Registration (Pairing) Rop-22 In The Exta Life System - Zamel Exta Life Rop-22 Bedienungsanleitung

REMOTE DELETION OF TRANSMITTER
BY MEANS OF EXTA LIFE APLICATION
In case we want to delete remotely transmitter's push-buttons from a receiver, it is required that
the receiver is paired with the EXTA LIFE controller. To do the above, the following steps must
be carried out:
1. Choose the "Configure" option from the receiver's (channel) menu ().
2. Choose "Assigned transmitters" () in the configuration menu to display a current list of trans-
mitters added to its memory ().
3. Press the transmitter's name to display details included in its memory (numbers of added push-
buttons, operation modes, assigned time in time mode).
4. Choose the „Delete" option from the transmitter's menu to delete selected push-buttons from a
receiver's memory (). A transmitter can also be deleted by sliding the element to the right or
left.

REGISTRATION (PAIRING) ROP-22 IN THE EXTA LIFE SYSTEM

In order to register ROP-22 in the system, it is necessary to connect the EXTA LIFE controller
in the system and to install the EXTA LIFE mobile application. The receivers must be connected
to 230 V AC. They are remembered in the system only after they have been properly paired with
a controller. To do it carry out the following steps:
1. Activate the application and enter the Device screen.
2. Choose the receiver tab and press „+" () to start the searching process of receivers installed
in the system. It lasts no longer than 60 seconds and can be stopped by means of the „Stop"
push-button. All receivers located within the controller are automatically displayed in a list
form with a default name including the receiver's name (ROP-22) + 6- digit ID serial number
assigned to this receiver ().
3. After searching has been completed (), press the 'TEST' button to quickly locate the receiver
(both receiver's outputs are switched on as long as the TEST push-button is pressed).
4. By marking fields next to the 'TEST' push-button, () we choose receivers to be paired with
the EXTA LIFE controller. It is possible to mark more than one receiver.
5. Press the 'PAIR' push-button to pair the marked receivers. After a while the receivers are
registered in the system and are visible on the list in the Receivers tab ().
6. After pairing ROP-22 receivers are always visible as two channels: Channel-1 (OUT-1) and
Channel-2 (OUT-2). A default icon is assigned to each channel.
7. The receivers, just after pairing, can be controlled at once by means of application buttons.
The receiver's mode is signalled by a switch position and a switch icon (). By default, control
   