Default Settings - Zamel Exta Life Rop-22 Bedienungsanleitung

Seite von 152

/ 152
Inhalt
Inhaltsverzeichnis
Lesezeichen

Inhaltsverzeichnis

Verfügbare Sprachen

CONNECTION

FUNCTIONALITY

1. The ROP-22 receiver can be simultaneously controlled by:

• EXTA LIFE system transmitters (switch on / switch off, bistable, monostable, time),

• EXTA LIFE mobile application, after pairing with a controller (switch on / switch off and time

modes)

• IN1, IN2 external inputs (operating mode depends on a switch type – see Functionality of

inputs).

2. Current receiver's output mode is shown in the mobile application.

3. It is possible to assign a larger number of push-buttons of EXTA LIFE transmitters to one re-

ceiver (channel) – maximum 96 pairs (e.g. 24 transmitters in the switch on/switch off mode).

4. Transmitters' push-buttons can be assigned to a receiver "locally" by means of a mobile applica-

tion.

5. Few transmitters can cooperate with one transmitter – it is recommended that a transmitter

is assigned to each receiver in the switch on / switch off mode.

6. A receiver can be paired only with one EXTA LIFE controller. After pairing the receiver is not

visible for other controllers.

7. Push-buttons added to a receiver's memory can be selectively deleted.

8. There is a possibility to delete simultaneously all push-buttons added to a receiver's memory

(reset to default settings).

9. Basic ROP-22 parameters are configured by means of a mobile application.

10. Parameters are independently configured for OUT1 and OUT2 outputs.

11. A remote software update of a receiver is also possible due to a mobile application (the EXTA

LIFE controller must be connected to the Internet).