ZAMEL exta life ROP-22 Bedienungsanleitung Seite 33

DELETING MEMORY OF A RECEIVER
After this operation, all push-buttons of transmitters added to a receiver's memory are deleted.
Erasing (deleting) the memory includes the receiver is unpaired from the EXTA LIFE control-
ler. If the receiver's memory included push-buttons assigned in time mode, then after memory
deletion the individually assigned push-buttons are also deleted. The zone time has a default
setting value - 10 seconds. All data assigned to channel-1 and channel-2 are also deleted. If
a user switched off deliberately pairing with the controller (see Switching off pairing - Broadcast
OFF), then deleting the receiver's memory switches on automatically the possibility of pairing
(default setting).
In order to delete the whole memory of a receiver (restoring default settings), the following steps
must be carried out:
1. Press the PROG. push-button for about 5 seconds –STATUS LED switches on orange.
2. After STATUS LED switches off, release the PROG. push-button and in < 5 sec. press it again
shortly.
3. The STATUS LED flashes orange to signal the deleting is ongoing. The STATUS LED flashes
orange quickly to signal the operation has been completed successfully.
SELECTIVE MEMORY DELETION OF RECEIVERS
In the EXTA LIFE system receivers, there is a possibility to delete selectively push-buttons from
a receiver's memory. It allows to delete selected buttons without deleting the whole memory of a
receiver. Push-buttons can be deleted directly (by means of the PROG. push-button) or remotely
by means of the EXTA LIFE application.
DIRECT DELETING OF PUSH-BUTTONS
BY MEANS OF PROG. PUSH-BUTTON
Selective deletion of push-buttons (or pairs for the switch on/switch off mode) from channel-1
of a receiver:
1. Press the PROG push-button for about 5 seconds –STATUS LED switches on orange.
2. After STATUS LED switches off, release the PROG. push-button and next within < 5 sec. press
shortly this push-button that is assigned to channel-1 and that will be deleted from the re-
ceiver's memory. In case a pair of push-buttons was assigned in a switch on/switch off mode,
press only one of the buttons.
3. The STATUS LED flashes orange to signal the procedure of selective deleting has been com-
pleted.
Selective deletion of push-buttons (or pairs for the switch on/switch off mode) from channel-2
of a receiver:
1. Press the PROG push-button for about 5 seconds –STATUS LED switches on orange.
2. After STATUS LED switches off, release the PROG. push-button and wait for about 5 seconds
till STATUS LED flashes blue. Next, press shortly this push-button that is assigned to chan-
nel-2 and that will be deleted from the receiver's memory. In case a pair of push-buttons was
assigned in a switch on/switch off mode, press only one of the buttons.
3. The STATUS LED flashes orange to signal the procedure of selective deleting has been com-
pleted.
(restoring default settings)