ZAMEL exta life ROP-22 Bedienungsanleitung Seite 28

Programming push-buttons to channel two (OUT-2)
e.g. 2 push-button remote control P-457/2
Switch on – switch off mode
1. Press the PROG. push-button shortly (1sec.) in a receiver – STATUS LED switches on blue.
2. Wait for about 5 seconds till STATUS LED switches on red.
3. In < 5 sec. press the push-button shortly that should realize the "switch on" function (for exam-
ple "1").
4. STATUS LED switches off and switches on red again.
5. In < 5 sec. press shortly the button that should realize the "switch off" function (for example "2").
6. The STATUS LED flashes orange to signal the push-buttons have been assigned correctly.
Bistable mode
1. Press the PROG. push-button shortly (1s). in a receiver –STATUS LED switches on blue.
2. Wait for about 5 seconds till STATUS LED switches on red.
3. In < 5 sec. press the button that should be added in a bistable mode (for example "1").
4. STATUS LED switches off and switches on red again.
5. In < 5 sec. release the button that should be assigned in the bistable mode (for example "1").
6. The STATUS LED flashes orange to signal the push-button has been assigned correctly.
Monostable mode
1. Press the button that should be added in a monostable mode (for example "1").
2. Keep the transmitter's push-button pressed and press the PROG. push-button shortly (1sec.)
in a receiver –STATUS LED switches on blue.
3. Wait for about 5 seconds till STATUS LED switches on red.
4. In < 5 sec. release the transmitter's button that should be assigned in the monostable mode.
5. STATUS LED switches off and switches on red again.
6. In <5 sec. press again shortly this push-button that should be assigned in the monostable
mode.
7. The STATUS LED flashes orange to signal the push-button has been assigned correctly.
TIME MODE
Step 1: Pairing a selected push-button with a receiver
1. Press the PROG. push-button shortly (1sec.) in a receiver –STATUS LED switches on blue.
2. Wait for about 5 seconds till STATUS LED switches on red.
3. In < 5 sec. press shortly the button that should be assigned in time mode (for example "1").
4. STATUS LED switches off and switches on red again.
5. In < 5 sec. press shortly this push-button that should be assigned in time mode (for example
"1").
6. The STATUS LED flashes orange (several times, quickly) to signal the push-button has been
assigned correctly.
After the selected push-button of a transmitter has been assigned to the second channel of ROP-22
in time mode, then the default time of this push-button will be 10 seconds. To change it, carry out
the time programming procedure (Step_2). In case of ROP-22, an individual time can be assigned
to each push-button paired with the second output (OUT-2). Time is programmed in the range from
1 second to 18 hours.
Step 2: Programming time assigned to a selected push-button in time mode
1. Press the PROG. push-button shortly (1sec.) in a receiver – STATUS LED switches on blue.
2. Wait for about 5 seconds till STATUS LED switches on red.
3. Wait again for about 5 seconds till STATUS LED switches off.
4. Wait again for about 5 seconds till STATUS LED flashes blue several times.