ZAMEL exta life ROP-22 Bedienungsanleitung Seite 27

Bistable mode
1. Press the PROG. push-button shortly (1sec). in a receiver –STATUS LED switches on blue.
2. In < 5 sec. press the button that should be added in a bistable mode (for example "1").
3. STATUS LED switches off and switches on blue again.
4. In < 5 sec release the button that should be assigned in the bistable mode (for example "1").
5. The STATUS LED flashes orange to signal the push-button has been assigned correctly.
Monostable mode
1. Press the button that should be added in a monostable mode (for example "1").
2. Keep the transmitter's push-button pressed and press the PROG. push-button shortly (1sec).
in a receiver –STATUS LED switches on blue.
3. In < 5 sec. release the transmitter's button that should be assigned in the monostable mode.
4. STATUS LED switches off and switches on blue again.
5. In <5 sec. press again shortly this push-button that should be assigned in the monostable
mode.
6. The STATUS LED flashes orange to signal the push-button has been assigned correctly.
Time mode
Step 1: Pairing a selected push-button with a receiver
1. Press the PROG. push-button shortly (1sec). in a receiver – STATUS LED switches on blue.
2. In < 5 sec. press the button that should be assigned in time mode (for example "1").
3. STATUS LED switches off and switches on blue again.
4. In < 5 sec. press shortly this push-button that should be assigned in time mode (for example
"1").
5. The STATUS LED flashes orange (several times, quickly) to signal the push-button has been
assigned correctly.
After the selected push-button of a transmitter has been paired with a given channel of ROP-22,
the default time of this push-button will be 10 seconds. To change it, carry out the time program-
ming procedure (Step 2). In case of ROP-22, an individual time can be assigned to each push-
button added to its memory. Time is programmed in the range from 1 second to 18 hours.
Step 2: Programming time assigned to a selected push-button in time mode
1. Press the PROG. push-button shortly (1sec.) in a receiver – STATUS LED switches on blue.
2. Wait for about 5 seconds till STATUS LED switches on red.
3. Wait again for about 5 seconds till STATUS LED switches off.
4. After the LED is switched off, in < 5 sec. press shortly the transmitter's push-button that is as-
signed to channel 1 in time mode, and that we want to programme time for.
5. The STATUS LED starts flashing blue – it means time is measured.
6. After the time we want to assign to a selected push-button is finished, press shortly the selected
push-button again.
7. The STATUS LED flashes orange to signal time has been programmed correctly.
Time assigned to a particular push-button can be changed only by repeating the programming pro-
cedure.