ZAMEL exta life ROP-22 Bedienungsanleitung Seite 26

PROGRAMMING EXTA LIFE TRANSMITTERS
• STATUS LED signals the programming procedure is ongoing.
• Operation related to the first output (OUT-1) is signalled by a switched on blue LED and to the
second output (OUT-2) by a red LED.
• Receiving / transmission is signalled by a short flashing of the green STATUS LED.
• Successful completion of a particular operation is signalled by a flashing (several times) orange
STATUS LED.
CAUTION! In ROP-22 receiver, the programmed operating modes are overwritten. If a se-
lected transmitter's push-button was assigned to a given output of a receiver in a bistable
mode, then to add the same push-button to this channel but in a different mode (e.g. time
mode), we do not need to delete this push-button from the receiver's memory. Time mode
replaces bistable mode immediately. The exception includes a situation where, e.g., push-
button "1" of a transmitter is assigned to output 1 in a bistable mode, and push-button "2"
is in the same mode, but assigned to output "2". To assign push-buttons 1 and 2 to the
same transmitter to output 1 in the switch on / switch off mode, it is necessary to delete
push-button 2 from output 2 first. It can refer to different configurations not included in
this manual.
• A receiver realizes only functions of those push-buttons that were added to it during program-
ming. It is possible to assign many push-buttons to one receiver in subsequent iterations of the
programming procedure (up to 96 pairs).
• In the EXTA LIFE system selected push-buttons of a transmitter are programmed with a re-
ceiver. It gives a huge flexibility during the programming procedure. For example, push-buttons
of a 4 push-button remote control P-457/4 can be programmed in the following way:
Push-button number
1
2
3, 4
• The same push-buttons can be simultaneously programmed to other receivers. In this case,
taking into account operation certainty and correctness, the switch on/switch off mode is rec-
ommended. In case of other operation modes, the jitter effect of receivers may occur.
• Push-buttons can be programmed directly in a receiver by means of the PROG. push-button
(an access to a receiver is required) or remotely (without an access to a receiver) by means of
the EXTA LIFE mobile application.
DIRECT PROGRAMMING BY MEANS OF PROG. PUSH-BUTTON
• To assign radio transmitters directly to a receiver, use the receiver's PROG. push-button.
Programming push-buttons to channel one (OUT-1)
e.g. 2 push-button remote control P-457/2
Switch on – switch off mode
1. Press the PROG. push-button shortly (1sec). in a receiver – STATUS LED switches on green.
2. In < 5 sec. press the button that should realise the "switch on" function (for example "1").
3. STATUS LED switches off and switches on blue again.
4. In < 5 sec. press the button that should realise the "switch off" function (for example "2").
5. The STATUS LED flashes orange to signal the push-buttons have been assigned correctly.
Operating mode
bistable – output 1
bistable – output 2
switch on/switch off – output
1 and 2
Receiver's reaction
OUT-1 output control
OUT-2 output control
3 – switching on outputs (OUT-1 and
OUT-2)
4 – switching off outputs (OUT-1 and
OUT-2)