General Power Tool Safety Warnings; Working Safely - Parkside PMDS 100 A1 Originalbetriebsanleitung

Weight (incl. accessories): 1750 g
*After a continuous operating time of 20 minutes, a
rest period is enabled, until the device has cooled to
a temperature within 2 K (2 °C) of the room tem-
perature.
Grinding discs
Outside diameter:
Drill hole:
Thickness:
Hardness:
Grain size:
Noise and vibration data:
Measured sound value determined according to
EN 61029. The A-rated noise level of the power
tool is typically:
Noise level L :
pA
Uncertainty:
Sound power level L
WA
Uncertainty:
Wear ear protection!
Total vibration values in accordance with EN 61029:
Vibration emission value a
Uncertainty K = 1.5 m / s
Note: The vibration level specified in these instructions
was measured in accordance with a standardised
measurement process and can be used to compare
tools. The vibration emission value specified can also
serve as a preliminary assessment of the exposure.
Introduction / General power tool safety warnings
Ø 50 mm
Ø 12.7 mm
13 mm
M
100 / 80
< 70 dB(A)
3 dB
: 76 dB(A)
3 dB
≤ 2.5 m / s 2
h
2
Different uses of the device give
rise to different vibration levels and in many cases
they may exceed the values given in these instructions.
It is easy to underestimate the vibration load if the
electrical power tool is used regularly in particular
circumstances.
If you wish to make an accurate assessment of the
vibration loads experienced during a particular pe-
riod of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
General power tool
safety warnings
warnings and all instructions.
Failure to follow the warnings and in-
structions may result in electric shock, fire and / or
serious injury.
Save all warnings and instructions for
future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-op-
erated (cordless) power tool.

Working safely

Keep the area you are working in tidy.
Untidiness in the working area can cause acci-
dents.
Consider external influences! Never
expose electronic devices to rain. Do not use
electronic devices in damp or wet surroundings.
Ensure that the working area is well lit. Do not
use electronic devices in areas where there is a
risk of fire or explosions.
Protect yourself against electric shocks!
Avoid bodily contact with earthed parts (e.g.
pipes, radiators, electric ovens, refrigerators).
Keep other people away! Do not allow
other persons, particularly children, to touch
Read all safety
GB/IE 7