Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Start-up / Maintenance and Cleaning / Service centre
ATTENTIoN! Repeat the settings on the op-
posite side.
Never press the spindle lock key
grinding disk
,
4 a
4 b
Switch the device on by pressing the ON / OFF
switch
.
10
Set the appropriate rotational speed using the
rotational speed control
Switch off the device by pressing the ON / OFF
switch
.
10
Attach the polishing mandrel
RISK oF INjURy! Remove
the mains plug from the mains socket before you
carry out any work on the appliance.
ATTENTIoN!
Never press the spindle lock key
grinding disk
,
4 a
4 b
Pull out the cap
5
Press the spindle lock key
Screw the polishing mandrel
Screw the desired polishing tool
or
onto the polishing mandrel
4 g
Cover the grinding disk
the protective hood
Reverse the order to disassemble the polishing
mandrel
after operation.
12
Changing the grinding disk
RISK oF INjURy! Remove the
mains plug from the mains socket before you carry
out any work on the appliance.
The grinding disk
used may not exceed the stated diameter.
Unscrew the fastening screws
the cover and remove the cover (s. fig. C).
Never press the spindle lock key
grinding disk
,
4 a
4 b
Press the spindle lock key
Unscrew the union nut
10 GB/IE
when the
1
is still rotating.
.
11
when the
1
is still rotating.
.
to block the shaft.
1
(s. fig. B).
12
,
,
4 c
4 d
4 e
(s. fig. B).
12
,
completely using
4 a
4 b
(s. fig. B).
2
,
being
4 a
4 b
on the side of
17
when the
1
is still rotating.
to block the shaft.
1
from the device.
16
Remove the safety washer
grinding disk
(s. fig. C).
Place the new grinding disk onto the centring
flange
and push them onto the shaft
14
(s. fig. C).
Thread the safety washer
onto the shaft
16
Keep the spindle lock key
the union nut
the grinding disk
cover.
Re-attach the lateral panel and fasten by tighten-
ing the retaining screws
Maintenance and Cleaning
the mains plug from the mains socket before you
carry out any work on the appliance.
The device requires no maintenance.
,
Clean the device immediately after finishing
4 f
your work.
Remove and empty the swarf compartment
to the side of the device (s. fig. D).
Use a dry cloth to clean the device. Never use
petrol, solvent or cleaners which attack plastic.
Always keep the vents clear.
Remove dust clinging to the device with a brush.
Service centre
repaired only by qualified specialist
personnel using original manufacturer
parts only. This will ensure that your device
remains safe to use.
lead needs to be replaced, always have
the replacement carried out by the
manufacturer or its service centre. This
will ensure that your device remains safe to use.
, union nut
15
,
and centring flange
4 a
4 b
and the union nut
15
.
13
pressed and tighten
1
.
16
RISK oF INjURy! Never use
,
without the protective
4 a
4 b
firmly.
17
RISK oF INjURy! Remove
have your device
If the plug or mains
,
16
14
13
9
Werbung
Kapitel
Inhaltsverzeichnis
