Before Use; Working Instructions; Dust Extraction; Start-Up - Parkside PMDS 100 A1 Originalbetriebsanleitung

Only use grinding wheels and brushes where
the printed rotational speed is equal to that spec-
ified on the type plate of the electronic device.
Periodically check the position of the spark de-
flector to compensate for wear of the disk. The
distance between spark deflector and disk should
be as small as possible and must not exceed
2 mm.
Always leave the brush connected to the spindle
in order to limit the risk of touching the rotating
spindle.
Remaining risks
Even with proper use of this power tool there are
always residual risks. The following hazards may
arise in connection with the construction and design
of this power tool:
a) Lung damage when appropriate breathing
protection is not worn.
b) Hearing damage when suitable hearing protec-
tion is not used.
c) Damage to health arising from vibration when
using the power tool for extended periods or
when used and maintained improperly.
This power tool generates an
electromagnetic field during use. This field could
possibly actively or passively impact medical implants.
To reduce the risk of serious or fatal injuries we rec-
ommend persons with medical implants consult their
physicians and the manufacturer of the medical im-
plant before using this machine.

Before use

Working instructions

(s. fig. E–G)
Little grinding pressure will suffice:
Work with low grinding pressure - it is mainly the
correct and constant rotational speed which yields
the best grinding performance.
Grinding:
Please consider that the worked piece will become
very hot when being worked. Please cool the piece,
therefore, first in a water bath.
General power tool safety warnings / Before use / Start-up
ATTENTIoN! This device is not suitable for
continuous operation.
Switch off the device immediately and allow to
cool in the event of overheating.

Dust extraction

FIRE hAzARD! Fire hazard
when using power tools with dust collection bin or
connected to a vacuum via dust extraction! Unfa-
vourable conditions, e.g. sparking - when grinding
metal or metal pieces in wood - can ignite wood
dust in the dust collection bin (or inside the vacuum
bag). This can particularly occur if the wood dust is
mixed with paint particles or other chemicals and
the ground product is hot after long work periods.
Avoid overheating the grinding material and the de-
vice. Before breaks always empty the dust collection
bin or the dust bag.
Wear a dust mask!

Start-up

Switching on / off

Note: Allow the grinding disk to run without any
load at the maximum rotational speed for around
five minutes before using for the first time. Leave the
danger area in this time.
Loosen the knurled screw
support and set the desired grinding angle
6
(s. fig. A).
Re-tighten the knurled screw
RISK oF INjURy! A distance
(gap) should be kept between the grinding disk
, and the workpiece support
4 a 4 b
working.
Loosen the tommy screw
hood and set it so that it offers the most
2
protection (s. fig. A).
Re-tighten the tommy screw
of the workpiece
8
.
8
when
6
of the protective
3
.
3
GB/IE 9