Sartorius PMA.Vision VIS1X Installationsanleitung Seite 27

CERTIFICATE OF COMPLIANCE
HAZARDOUS LOCATION ELECTRICAL EQUIPMENT
This certificate is issued for the following equipment:
YCO14-Z Ex-Link Converter
AIS / I / 1 / CD Ta = 0°C to 40°C
[I / 1] / [Ex ib IIB] Ta = 0°C to 40°C
Specific Conditions of Use
1. The YCO14-Z Ex-Link Converter shall only be used with the PMA.Evolution.
2. The protective ground connectors on the PMA.Evolution and the YCO14-Z
together using a potential equalisation conductor with a cross-sectional area of at least 4 mm
3. The CAT6 cable used between the PMA.Evolution and the YCO14-Z
Sartorius.
PMA.Evolution EVO1Xab-c
IS / I / 1 / CD / T4 Ta = 0°C to 40°C
I / 1 / Ex ib IIB / T4 Ta = 0°C to 40°C
a = Up to three letters and/or numbers or blank (not critical to safety)
b = Up to two letters and/or numbers or blank (not critical to safety)
c = Up to five letters and/or numbers or blank (not critical to safety)
Specific Conditions of Use
1. The PMA.Evolution shall only be used with the
2. The protective ground connectors on the PMA.Evolution and the YCO14-Z
together using a potential equalisation conductor with a cross-sectional area of at least 4 mm
3. The CAT6 cable used between the PMA.Evolution and the YCO14-Z
Sartorius.
4. The enclosure of the PMA.Evolution is non-conducting and may generate an ignition-capable level of electrostatic
charges under certain extreme conditions. The user shall ensure that the equipment is not installed in a location
where it may be subjected to external conditions that might cause a build-up of electrostatic charges on non-
conducting surfaces, additionally; cleaning of the equipment should be done
PMA.Evolution LAB1Xab-c
IS / I / 1 / CD / T4 Ta = 0°C to 40°C
I / 1 / Ex ib IIB / T4 Ta = 0°C to 40°C
To verify the availability of the Approved product, please refer to www.approvalguide.com
FM Approvals HLC 5/13
FM Approvals
1151 Boston Providence Turnpike
P.O. Box 9102 Norwood, MA 02062 USA
T: 781 762 4300 F: 781-762-9375 www.fmapprovals.com
PER CANADIAN REQUIREMENTS
YCO14-Z Ex-Link
«PeopleSoft_Project_ID»
Page 1 of 3
Deutsch
Ex-Link Converter shall be connected
2
.
Ex-Link Converter shall be obtained from
Converter
Ex-Link Converter shall be connected
2
.
Ex-Link Converter shall be obtained from
only with a damp cloth.
Installationsanleitung VIS1X 27