Fault Codes And Troubleshooting - Rcb Rk8S Originalbetriebsanleitung

Fault codes and troubleshooting methods
Error code
E00
E06
Battery Undervoltage
E07
E09
E10
E11
Deutsch /
Code meaning
Motor Failure
Controller Failure
Communication
Receiving Failure
Communication
Sending Failure
English / Français / Español / Italiano / Nederlands / Polski
Inspections
Normal Status
Check that the battery is fully charged. If this
error code still appears after a full charge you
need to replace the battery.
Check the rear wheel motor wiring for damage,
if the error code still appears after replugging
or damaged, the motor will need to be
replaced.
Check all wiring on the controller for damage, if
the error code still appears after replugging or
damaged, the controller will need to be
replaced.
1.Check whether there is any damage in the
display wire.
2.Check whether the controller and display plug
connection is intact.
3. Unplug the power sensor to see if it reports
error, not report that is the sensor short-circuit
damage, need to replace the sensor.
4. Unplug the motor line to see if the error, not
reported that the motor hall short circuit damage,
need to replace the motor to solve the problem.
5. The above can not solve the problem with the
replacement method, replace the controller or
display to troubleshoot the problem.
1.Check whether there is any damage in the
display wire.
2.Check whether the controller and display plug
connection is intact.
3. Unplug the power sensor to see if it reports
error, not report that is the sensor short-circuit
damage, need to replace the sensor.
4. Unplug the motor line to see if the error, not
reported that the motor hall short circuit damage,
need to replace the motor to solve the problem.
5. The above can not solve the problem with the
replacement method, replace the controller or
display to troubleshoot the problem.
(71)