Legal Requirements; Check The Tyre Air Pressure - Rcb Rk8S Originalbetriebsanleitung

Legal Requirements

If you want to ride your e-bike on public roads, you must equip it in accordance with national
regulations. Legally, our 25 km/h models are treated in the same way as bicycles and are
therefore subject to the same regulations. In Germany, these issues are regulated by the
Road Traffic Permit Ordinance (StVZO) and the Road Traffic Ordinance (StVO).
- Bells
- Two independently operating brakes
- One white headlight at the front
- White reflective front spotlight
- Red light
- Red reflector at the rear of the bicycle
- Yellow reflectors at the front and rear of the pedals
- Two yellow reflectors offset by 180° on the spokes of each wheel or a continuous white
reflective stripe in a ring on the tyre.
Pre-ride Inspection Steps:
- The quick release/centre shaft is securely installed and closes securely.
- Screw connections are neither loose nor rattling.
- The handlebars are securely fastened.
- Wheels and tyres turn easily and run smoothly.
- The tyres are checked for air pressure and condition and the valves are correctly in place.
- Front and rear lights work properly and have been correctly adjusted.
- Brake levers have clear points of tension.
- Brake pads and discs are undamaged and free of oil. They should also be checked for wear.
- The battery must be securely in place when inserted. The battery must engage in the lock and
make a clicking sound.
- The permissible total load weight is not exceeded.
- Lights and reflectors are not covered.
- Battery is charged
- Saddle is securely fastened and correctly adjusted
- Pedals are securely fastened

Check the Tyre Air Pressure

You can find the permissible tyre inflation pressure on the side of the tyre. We recommend using a
bicycle floor pump with a pressure meter to check and correct the tyre inflation pressure.
Note for American valve:
- Unscrew the plastic nut from the valve head.
- Press the valve end gently towards the rim. If there is pressure in the tyre, you will hear air releasing.
-When the inflation process is finished, tighten the plastic nut again.
Deutsch / English / Français / Español / Italiano / Nederlands / Polski
(54)