The "Programming" Menu - FLEISCHMANN multiMAUS 686701 Handbuch

All the values of a decoder (NMRA / DCC) are stored in what are referred to as confi guration variables, the
CVs. Using the "PROGRAM" menu you can adjust these values to your needs.
Fleischmann decoders already installed in locomotives are usually delivered with the suitable settings.
You should therefore check before performing programming whether it is really necessary.
The Fleischmann amplifi er 680801 and the Roco booster 10765 cannot read the CVs from a decoder. The
values shown on the display screen of the multiMAUS are fi ctitious suggested values and do not match
the genuine values. The values which your program, on the other hand, are the genuine values. Use
either devices capable of reading (e.g. a PC with ROCOMOTION 10785 or the PROFI-BOSS 686601) or
write down the old and new decoder values. See the instruction manual for your decoder or locomotive.
2.1. "CV MODIFICATION"
This is where you can read CVs (see above) or give them new values. The fi rst display screen shows
the text "CV" and a fl ashing cursor. You can now enter the number of the CV you require using the
„function keys".
– To confi rm, press the "Light / OK" key.
The displayed value is either fi ctitious, a suggested value or – when using a booster which can read
– the current genuine value. If you only wish to read the values, exit the menu item by pressing
"STOP".
– Then enter the required value and confi rm by pressing the "Light / OK" key. The display switches
briefl y to "PROG" before you return to the start level "CV MODIFICATION".
2.2. "LONG ADDRESS"
Only locomotive addresses from 1 – 99 can be stored in CV1. All locomotive addresses from 100
onwards must be programmed using this menu item. To do so it is fi rst necessary to enable "long
addresses" in the locomotive decoder using CV29 (see decoder operating manual!)
When calling up this menu item, "CV 17 / 18" is briefl y displayed. The display then switches imme-
diately to a four digit "suggested value" with a letter "L" prefi x and a fl ashing cursor. You can now
enter the number of the address you require using the function keys. The numbers of the suggested
value disappear once the fi rst number has been entered.
– To confi rm, press the "Light / OK" key. The display switches briefl y to "PROG" before you return to
the start level "LONG ADDRESS".
2.3. "MODE"
The multiMAUS is set to "CV programming mode" in the factory. However, if you wish to program
locomotives without using a separate programming track, set the multiMAUS to „POM" mode.
"POM" stands for "programming on the main" which means that you can program the locomotive,
which is selected on the multiMAUS (only with decoders that have that feature).
A decoder reset may need to be performed. See "H
for the locomotive being programmed cannot be programmed in "POM" mode. Select the required
programming mode using one of the arrow keys.
– To confi rm, press the "Light / OK" key. You return to the start level "MODE".
2. T M "P
HE ENU ROGRAM
"
, T H " on page 58. CV1 (address)
INTS IPS AND ELP
GB
49