Storage; Spare Parts/Accessories; Disposal, Environmental Protection - FLORABEST FGH 750 A1 Originalbetriebsanleitung

Make sure that the tines are set to
their proper turning direction. The
arrows on the gearbox and tines
should point the same way (see

).
5. Slide the hex bolt through the
hole and tighten on the self-lock-
ing nut (supplied with each new
tine wheel pair (see

Storage

• Leave the motor to cool down before
you put the tool into a closed space.
• Keep the tool clean, dry and out of the
reach of children.
• Do not cover the tool in plastic bags as
moisture may form.

Spare Parts/Accessories

If you do not have internet access, please contact the Service Centre via telephone (see
"Sercice-Center" Page 15). Please have the order number mentioned below ready.
Set of tines Right/left ............................................................... Order No. 91104325
Disposal, environmental
protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have finished with
them.
IB_270725_FGH750A1_CB-4_rev02_20151130-ts.indb 13
Ž
D
)).
Spare parts and accessories can be obtained at
www.grizzly-service.eu
Unscrew the wing nuts
E
and fold the fork grips down to re-
duce the space taken by the tool.
D The frame tubing (6) also serves as
a hook to hang up the tool at the
place of storage.
Make sure that the cable does not
become jammed.
Do not use the tool
with the handle folded
closed. There is a risk of
injury!
Do not dispose of electrical appli-
ances in household waste.
Return the tool to a recycling centre. The
plastic and metal parts used can be sepa-
rated and sorted for recycling. Ask our
service centre for details.
GB
13
01.12.15 08:47