Maintenance - Ruris Rx300S Bedienungsanleitung

EN
When the control lever is moved towards the rabbit symbol the engine speed increases.
When the control lever is moved to the frog symbol the engine speed decreases.
CAREFUL!
Operate the lever only when the engine is running. Operating the lever without the engine running can
damage the drive mechanism.
To decrease travel speed, push the lever in the forward direction.
To increase travel speed, pull the lever back.
The travel speed will be suitable according to the working conditions (land and lawn).
CUTTING HEIGHT ADJUSTMENT
NOTE: Your machine is shipped with the cutting height in the low position. Adjust the cutting height as
follows.
The height adjustment lever is located above the right rear wheel. To adjust the cutting height, move the
lever outwards and move it forward or backward one step.
NOTE: For uneven or unstable terrain, move the cutting height to a higher position.
Caution: Be sure to disconnect the spark plug plug before performing repairs
or maintenance.
NOTE: When tipping the lawnmower, empty the tank. Do not turn the clipper more than 90 degrees in any
direction or leave the clipper upside down for long periods of time. Oil can leak into the top of the engine
and cause starting problems.
● Change the engine oil after the first 5 hours of operation, which is the break-in period, then every 25
hours of operation or every 6 months. Read and follow the instructions carefully.
●
Check the air filter after 25 hours under normal conditions. Clean it every two hours in dusty
conditions. Low engine performance indicates that the air filter needs to be cleaned.
●
The air filter should be cleaned. At the beginning of each mowing season it is recommended that the
filter be replaced. Carefully remove the pre-filter (if fitted) and cartridge assembly from the cover.
14
mic mare

9. MAINTENANCE

Relaxed handle
Cutting height