Emptying The Collection Bag - Ruris Rx300S Bedienungsanleitung

EN
NOTE: For best results, raise the cutting position until you determine which height is best for the machine.
CAUTION: The blade continues to rotate for several seconds after the engine is turned off.
USING THE LAWN MOWER
● Make sure there are no stones, sticks, wires or other objects in the mowing area that could damage
the lawnmower or the engine. Such objects could be accidentally thrown in any direction and cause
personal injury to the operator or others.
●
For best results, do not cut wet grass as it may stick to the inside of the tub.
●
The lawnmower engine must be kept at maximum speed for optimal cutting.
Attention: If the car hits a foreign object, stop the engine, check the car
carefully for damage. If the machine continues to vibrate during operation, it
indicates a problem.
Collection bag
This machine can store grass clippings.
● Raise the rear canopy.
● Insert the lawn bag behind the awning rod.
●
Release the rear cover to secure the collection bag in place.

Emptying the collection bag

Hold the grass bag by the two rear and bottom handles and lift it up. The canopy will turn around the rod
and out of the collection bag. Then remove the collection bag from behind the canopy rod on the car.
While holding the bottom
handle, lift the rear section of
the grass bag as shown in
the adjacent figure. The cut
lawn will fall. When attaching
the grass bag, make sure
that the grass bag hook rests
on the canopy rod, between
the right and left sides of the
console.
Height handle adjustments
The machine gives you several positions for the handle and it is sent with it in the middle position. To adjust
the height proceed as follows:
12
Copertina Tija
Hook
Hooks