Problem Guide; Storage - Ruris Rx300S Bedienungsanleitung

EN
Problems Cause
○ Knife handle stop is disconnected
The engine
○ Spark plug disconnected
does not start
○ Throttle cable misaligned
○ The tank is empty or the fuel is out
of date
○ Gasoline valve blocked
○ Defective spark plug or spark plug
○ Drowned engine
○ The machine moves to the starting
The engine
runs with position
speed
○ Interrupted ignition
fluctuations
○ Gasoline valve blocked or old fuel
○ Water or dirt in the fuel
○ Clogged air filter
○ Carburetor out of order
○ Engine oil below level
Overheated
○ Low air circulation
engine
○ Carburetor not properly adjusted
○ Clogged carburetor
Interruptions
○ Defective spark plug
in engine
○ Defective spark plug or cable
speed at high
speeds
○ Loose cutter or unbalanced
Excessive
vibration machine
○ Engine speed too low
The machine
does not cut
○ Wet lawn
the lawn
○ Grass too tall
○ Knife damaged (not sharp)
○ Wheels not properly positioned
Uneven cut
○ Used knife
NOTE: For repairs other than the above adjustments, contact the nearest authorized RURIS service
The following steps must be followed to prepare the lawnmower for storage.
●
Clean and lubricate the machine carefully as described in the instruction manual.
●
Coat the machine knife with petroleum jelly to prevent rusting.
●
Store the machine in a dry and clean area. Do not store it near corrosive material or heating sources
(central, stoves).
● Empty the fuel from the tank.
● Start the machine and let it run until the fuel in the carburetor is used up and it stops.
17

10. PROBLEM GUIDE

means
○ Tighten the knife stop handle
○ Connect the spark plug
○ Check the cable source
○ Fill the tank or change the fuel
○ Clean the fuel valve
○ Clean the holes or change the plug or
spark plug
○ Ventilate the combustion chamber
○ Change the gear lever to fast (fast)
○ Connect and tighten the spark plug plug
○ Clean the valve and fill the tank with fuel
○ Empty the tank and replace the fuel
○ Clean the air filter or replace it.
○ Adjust the carburetor
○ Change the oil or top up
○ Clean the cooling spaces
○ Adjust the carburetor
○ Clean the carburetor
○ Replace the spark plug
○ Replace the plug or ignition
○ Tighten the blade to the adapter
○ Check the blade balance
○ Change the blade.
○ Adjust carburetor or governor levers
(service).
○ Do not mow the lawn when it is wet, wait
until it dries.
○ Cut once to high height then cut again to
desired height
○ Sharpen or replace the knife
○ Place all wheels in the same position
○ Sharpen or replace the knife

11. STORAGE