Vibration And Noise Reduction; Behaviour In Emergency Situations; Residual Risks - Parkside Performance Pabsp 20 Li C4 Bedienungsanleitung

2. Safety instructions when using long
drill bits
1) Never operate at higher speed
than the maximum speed rating of
the drill bit. At higher speeds, the
drill bit is likely to bend if allowed to
rotate freely without contacting the
workpiece, resulting in personal injury.
2) Always start drilling at low speed
and with the drill bit tip in contact
with the workpiece. At higher
speeds, the drill bit is likely to bend
if allowed to rotate freely without
contacting the workpiece, resulting in
personal injury.
3) Apply pressure only in direct line
with the drill bit and do not apply
excessive pressure. Drill bits can
bend causing breakage or loss of
control, resulting in personal injury.
˜ Vibration and noise reduction
To reduce the impact of noise and
vibration emission, limit the time of
operation, use low-vibration and low-noise
operating modes as well as wear personal
protective equipment.
Take the following points into account to
minimise the vibration and noise exposure
risks:
Only use the product as intended by
its design and these instructions.
Ensure that the product is in good
condition and well maintained.
Use correct accessory tools for the
product and ensure they are in good
condition.
Keep tight grip on the handles/grip
surface.
Maintain this product in accordance
with these instructions and keep it well
lubricated (where appropriate).
Plan your work schedule to spread any
high vibration tool use across a longer
period of time.
˜ Behaviour in emergency
situations
Familiarise yourself with the use of this
product by means of this instruction
manual. Memorise the safety warnings
and follow them to the letter. This will help
to prevent risks and hazards.
Always be alert when using this
product, so that you can recognise and
handle risks early. Fast intervention
can prevent serious injury and damage
to property.
Switch the product off and
disconnect it from the mains if there
are malfunctions. Have the product
checked b a qualified professional
and repaired, if necessary, before you
operate it again.
˜ Residual risks
Even if you are operating this product
in accordance with all the safety
requirements, potential risks of injury and
damage remain. The following dangers
can arise in connection with the structure
and design of this product:
Health defects resulting from vibration
emission if the product is being used
over long periods of time or not
adequately managed and properly
maintained.
Injuries and damage to property due to
broken accessory tools or the sudden
impact of hidden objects during use.
Danger of injury and property damage
caused b fl ing objects.
GB/IE 37