Turning Power On - Sharp Multisync Pn-M322 Installationsanweisung

Turning power on

1. Press the POWER button or MONITOR ON button to turn the power ON.
The Main Power switch must be in the ON position in order to power up the monitor using
the POWER button on the remote control unit or on the monitor.
Power LED
lighting pattern
Glowing blue
Blinking green*
Glowing amber*
(Networked
standby mode)
Blinking amber*
(Standby mode)
Glowing red
* : [POWER SAVE] is set to [ENABLE].
1
* : Time setting for auto power save is available at [POWER SAVE SETTINGS].
2
16
E
POWER Button
Power on Normal
Input signal Under any of the conditions below, no input signal
1
waiting has been detected by the monitor during the period of
mode time*
•
•
•
Under any of the conditions below, no input signal
1
has been detected by the monitor during the period of
time*
•
•
•
•
No AV signal input has been detected by the monitor
1
during the period of time you set. (No network signal
input [RS-232C] is set to [CONTROL TERMINAL]
under [EXTERNAL CONTROL] in [SYSTEM].)
Power off Turn off the monitor by the remote control or the
monitor button.
Status of the monitor
you set:
2
[AUTO INPUT CHANGE] is set to a setting except
for [NONE].
[USB POWER] is set to [ON].
[QUICK START] is set to [ENABLE].
you set:
2
A network signal input is present and [LAN] is set
to [CONTROL TERMINAL] under [EXTERNAL
CONTROL] in [SYSTEM].
[CEC] is set to a setting except for [OFF].
[OFF TIMER] is set to [ON].
[SCHEDULE INFORMATION] function is enabled.