Specifications - Sharp Multisync Pn-M322 Installationsanweisung

nOperations after first power-on
When you turn on the power for the first time, the initial setting screen appears. Navigate
the cursor to [Start] using the ▲/▼ buttons on the remote control unit and press the SET
button to start. Configure the initial settings, such as setting the language, date and time,
etc.
Turning power off
1. Press the POWER button again on the monitor or press the STANDBY button on
the remote control unit. The power is turned off. (Standby state)
Model
Power requirement
Operating temperature*
Operating humidity
Operating altitude
Storage temperature
Storage humidity
Power consumption*
(Max/networked standby mode*
standby mode* /off mode)
4
Dimensions (excluding
protrusions) inch (mm)
Weight lbs. (kg)
* : Temperature condition may change when using the monitor together with the optional equipments
1
recommended by SHARP. In such cases, please check the temperature condition specified by
the optional equipments.
* : Factory setting. (When no optional part is attached.)
2
* : Time for power management function: 10 sec.
3
* : Time for power management function: 3 min. and 10 sec.
4
As a part of our policy of continuous improvement, SHARP reserves the right to make design and
specification changes for product improvement without prior notice. The performance specification
figures indicated are nominal values of production units. There may be some deviations from these
values in individual units.

Specifications

1
2
/
3
PN-M322
AC 100 - 240 V, 0.8 A - 0.3 A, 50/60 Hz
32 °F to 104 °F (0 °C to 40 °C)
20% to 80% (no condensation)
3000 m or less
-4 °F to 140 °F (-20 °C to 60 °C)
10% to 80% (without condensation)
40 W
(75 W/2.0 W/0.5 W/0.0 W)
Approx. 28-5/8 (W) x 2-5/8 (D) x 16-3/4 (H)
(726.5 x 66.5 x 425.4)
Approx. 13.9 (6.3)
17
E