Sharp MultiSync PN-M322 Installationsanweisung Seite 9

Do not install the product in the locations below:
• Poorly ventilated spaces.
• Near a radiator, other heat sources, or in direct sunshine.
• Continual vibration areas.
• Humid, dusty, steamy, or oily areas.
• An environment where there are corrosive gases (sulfur dioxide,
hydrogen sulfide, nitrogen dioxide, chlorine, ammonia, ozone, etc.).
• Outdoors.
REQUIRED
• High-temperature environment where humidity changes rapidly and
condensation is likely to occur.
• A ceiling or wall that is not strong enough to support the product and
mounting accessories.
Do not mount the product upside down.
Prevent tipping and falling for earthquakes or other shocks.
To prevent personal injury or damage to the product caused by tipping
over due to earthquakes or other shocks, make sure to install the product
in a stable location and take measures to prevent falling.
The measures to prevent falling and tipping are intended for reducing
the risk of injury, but may not guarantee the effectiveness against all
earthquakes.
The product may tip causing personal injury.
• When using the product with the optional table top stand, fasten the
product to a wall using a cord or chain that can support the weight of
the product in order to prevent the product from falling.
• Depending on the table top stand, the stand has the structure for
preventing tipping.
• Please refer to the table top stand manual.
REQUIRED
• Be sure to remove the cord or chain from the wall before moving the
product to prevent personal injury or damage to the product.
The product may fall causing personal injury.
• Do not attempt to hang the product using an installation safety wire.
• Please install the product in an area on the wall or ceiling strong
enough to support the weight of the product.
• Prepare the product using mounting accessories, such as hook,
eyebolt, or mounting parts, and then secure the product with a safety
wire. The safety wire must not be tight.
• Please make sure the mounting accessories are strong enough to
support the product weight and size before installing it.
WARNING
5
E