Turning Power On/Off; Turning On The Main Power - Sharp PN-L752B Installationsanleitung

TIPS
• To use the touch panel with an HDMI / D-sub connection, connect the supplied USB cable to the computer.
The touch panel and touch pen operate with the standard driver of each operating system. On the Mac, operation is only
possible in mouse mode.
• The Information Display Downloader can also be downloaded from the following website.
https://www.sharp.eu/download-centre
When the Information Display Downloader is installed, you can check and download the most recent versions of the software
programs.
To install the software, see the manual for each.
Pen Software setup program and Touch Viewing Software setup program can be downloaded using Information Display
Downloader.
• The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of
HDMI Licensing Administrator, Inc.
• Google and Android are trademarks or registered trademarks of Google LLC.
• VESA is either registered trademark or trademark of Video Electronics Standards Association in the United States and/or
other countries.
• All other brand and product names are trademarks or registered trademarks of their respective holders.
Caution
• Turn on the monitor first before turning on the computer or
playback device.
• When switching the main power switch or the POWER
button off and back on, always wait for at least 5 seconds.
A short interval may result in a malfunction.

Turning on the main power

Main power switch
Off mode, when main power is off.
Caution
• The main power must be turned on/off with the main power
switch. Do not connect/disconnect the power cord or turn
the breaker on/off while the main power switch is on.
• For a complete electrical disconnection, pull out the main plug.

Turning Power On/Off

Turning power on
1. Press the POWER button.
Blue lit
Orange lit
Blue flashing
* Standby mode when "Power Save Mode" is set to on.
POWER button / Power LED
Status Status of the monitor
Power on
Sleep state (Backlight off)
Power off (Standby state*)
Input signal waiting state
7
E