Attaching And Removing The Attachment Tool; Instructions For Accessories - Parkside Performance Pbsap 20-Li A1 Originalbetriebsanleitung

GB MT
• 1 Screw
To use the screw operating
mode, switch the slip clutch on.
Set the function selector switch
(4) so that the arrow mark points
to the screwing symbol (
• 2 Drilling
To use the drill operating mode,
switch the slip clutch off. Set the
function selector switch (4) so
that the arrow mark points to the
drilling symbol (
• Torque adjustment ring (3)
Setting the maximum screwing
torque at which the slip clutch trig-
gers.
NOTICE! Only operate the torque
adjustment ring when the tool has
stopped!
• 1 Lowest torque
• 21 Maximum torque
For safety, start screwing at low
torque. Increase the torque as
required.
• On/Off switch (17)
• After inserting the battery: Con-
necting to the PARKSIDE app
• Switching on: Press
• Infinitely variable speed regula-
tion: The more you press the on/
off switch, the higher the speed.
• Switching off: Release
• "Connected" display (16)
Status of the connection with the
PARKSIDE app
flashing connection attempt
continuous light connection es-
tablished
Attaching and removing the
attachment tool
Notes
• Chuck capacity: 1.5-13 mm
• The direction of rotation is en-
graved in the keyless chuck (2).
30
• There is a magnetic recess at the
Attaching the attachment tool
(Fig. B)
).
1. Open the drill chuck: RELEASE➞
2. Push the attachment tool as far as
3. Clamp the attachment tool: ⬅GRIP
Removing the attachment tool
).
(Fig. B)
1. Open the drill chuck: RELEASE➞
2.
Using a ratchet screwdriver/
screwdriver bit holder
1. Place the desired screwdriver bit
2. Only for ratchet screwdriver (22):

Instructions for Accessories

Measuring tape
1. Press and hold one of the locking
2. Push the locking slider (24.2) for-
3. Release the fixation by pulling
You can use the clip (24.3) on the
back to attach the measuring tape to
your belt.
back under the handle (9) to hold
frequently used screw bits.
possible into the drill chuck open-
ing (1).
CAUTION! Risk of burn injury!
Attachment tools – especially drills
– can become very hot. Wear pro-
tective gloves whenever appropri-
ate.
Remove the attachment tool.
(27) in the ratchet screwdriver (22)/
screwdriver bit holder (23).
Select the direction of rotation by
☜☞
moving the arrow to the desired
mark on the handle.
buttons (24.1) to temporarily fix the
pulled-out measuring tape (24).
ward to permanently fix the pulled
out measuring tape.
back the locking slider (24.2).