IKEA Finputsad Gebrauchsanweisung Seite 22

ENGLISH
13
What to do if ...
In case your dishwasher doesn't work properly. check if the problem can be solved by going through the
following list. For other errors or issues please contact authorized After-sales Service which contact details can
be found in the warranty booklet. Spare parts will be available for a period of either up to 7 or up to 10 years.
according to the specific regulation requirements.
The
spare parts can
be
found:
btIwu
Problems... Possible causes... Solutions...
Salt reservoir is empty. (After
refill the salt indicator may
remain lit for several wash
cycles).
Refill reservoir with saI (for more information - see page 7)
Adjust water hardness - see table, page 8.
g Salt indicator is lit
Rinse aid dispenser is empty
(After refill the rinse aid indicator
may remain lit for several wash
cycles),
Refill dispenser with rinse aid (for more information - see
page 8).
J:k Rinse aid indicator is lit
The appliance has not been
plugged in properly
Insert the plug into the socket
The dishwasher won't start
or does not respond to
commands.
Power outage.
The dishwasher starts automatically when the power returns.
The dishwasher door is not
closed
Vigorously push the door until you hear the "click"
It does not respond to
commands. Display shows: 9 or
12 and On/Off LED is blinking
rapidly.
Switch off the appliance by pressing the ON/OFF button,
switch it back on after approximately one minute and reset
the program, if problem persists, unplug the appliance for 1
minute, then plug it back in
The wash cycle has not finished
yet
Wait until the wash cycle finishes
The dishwasher won't drain.
Display shows: 3 and
On/Off LED is blinking
rapidly
The drain hose is bent. Check that the drain hose is not bent (see INSTALLATION).
The sink drain pipe is blocked.
Clean the sink drain pipe.
The filter is dogged up with food
residues
Ctean the filter (see CLEANING THE FILTER ASSEMBLY).
The dishes are rattling against
each.
Arrange the crockery correctly (see LOADING THE RACKS).
The dishwasher makes
An excessive amount of foam
has been produced.
The detergent has not been measured out correctly or it is not
suitable for use in dishwashers (see FILLING THE DETERGENT
DISPENSER). Reset the current cycle by switching OFF the
dishwasher, then switch it on again, select a new program,
press START/Pause and dose the door within 4 seconds.
Please do not add any detergent.
excessive noise.
The crockery has not been
arranged properly
Arrange the crockery correctly (see LOADING THE RACKS).
The spray arms cannot rotate
freely, being hindered by the
dishes.
Arrange the crockery correctly (see LOADING THE RACKS).
The wash cycle is too gentle and/
or detergent efficiency is low.
Select an appropriate wash cycle (see PROGRAMS TABLE).
The dishes are not clean.
An excessive amount of foam
has been produced.
The detergent has not been measured out correctly or it is not
suitable for use in dishwashers (see FILLING THE DETERGENT
DISPENSER).
The cap on the rinse aid
compartment has not been shut
correctly.
Make sure the cap of the rinse aid dispenser is closed
The filter is soiled or doggec!
Clean the filter assembly (see CARE AND MAINTENANCE).
There is no salt Fill the salt reservoir (see FILLING THE SALT RESERVOIR).