IKEA Finputsad Gebrauchsanweisung Seite 21

ENGLISH
11
appears on the display, press button E until you
reach the desired letter (or mode), hold down button
Eg to confirm the selection.
Note: if NaturaIDry is active and it opens the door, then
Operation Indicator will not flash at the end of cycEe.
NATURALDRY
Door opening system NaturaIDry is a convection drying system
which automatically opens the door during/after drying phase
to ensure exceptional drying performance every day. Door
opens at the temperature that is safe to your kitchen furniture.
As additional steam protection, special designed protection foil
is added together with the dishwasher. To see how to mount
protection foil please refer to (INSTALLATION GUIDE).
NaturaIDry functionality could be disabled by the user as
follows:
1. Go to the Operation Indicator menu as in last step, press and
hold Eg untIl menu appears.
2. Press and hold Eg agaIn for 6 seconds to reach the
NaturaIDry menu.
3. You switched to NaturaiDry Control Menu. you could change
status of NaturaIDry functionality by pressing button:M
E - enabled d - disabled
To confirm the change and exit from the Control Menu
please press and hold Ea button (3 sec).
DOOR OPENING
after 165 min
80-170 min*
end of cycle
N/A
end of cycle
end of cycle
end of cycle
N/A
N/A
N/A
Eco 50'
AUTO 50'- 60'
Intensive 65'
Fast wash 30' 50'
Fast wash and dry 50'
Glass 45'
Silent 50'' (Night program)
Sanitizing 65'
Pre-Wash
Self-Clean 65''
* depending on settings
Program
Available
functions +)
g (R (TF a'©
gaGE ©
Ha (JIF a
ga
@
ga
a'©
BiG
F@
gn
£i'@
Ha
en
Duration of
wash program
(h:min)++)
3:40
1:20 - 3:00
2:40
0:30
1 :20
1 :40
3:35
1 :40
0:10
0:50
Water
consumption
(litres/cycle)
8.7
7.0 - 14.0
17.0
9.0
10.0
12.0
16.5
12.0
4.5
9.5
Energy
consumption
(kWh/cycle)
0.59
0.70 - 1.10
1.30
0.50
1.10
1.00
1.00
1.30
0.01
0.70
1 Eco
2 Auto
3 Intensive
4 Fast wash 30'
5 Fast wash and Dry
6 Glass
7 Silent
8
Sanitizing
9 Pre-Wash
10 Self-Clean
ECO program data is measured under laboratory conditions
according to European Standard EN 60436:2019.
Note for Test Laboratories: For information on comparative
EN testing conditions, please send an email to the following
address: dw_test_support@whirlpool.com
Pre-treatment of the dIShes is not needed before any of the
programs
*) Not all options can be used simultaneously.
+*) Values given for programes other than the eco program are
indicative only. The actual time may vary depending on many
factors such as temperature and pressure of the incoming
water, room temperature, amount of detergent, quantity and
type of load, load balancing, additional selected options and
sensor calibration.
1. ECO - Eco program is suitable to clean normally soiled
tableware, that for this use, it is the most efficient program
in terms of its combined energy and water consumption,
and that it is used to assess compliance with the EU
Ecodesign legislation.
AUTO - For normally soiled dishes with dried food residues.
Senses the level of soiling on the dishes and adjusts the
program accordingly. When the sensor is detecting the
soil level an animation appears in the display and the cycle
duration is updated.
INTENSIVE - Program recommended for heavily soiled
crockery, especially suitable for pans and saucepans (not to
be used for delicate items).
2
3
4. FAST WASH 30' - Program to be used for half load of lightly-
soiled dishes with no dried food residues.
FAST WASH AND DRY - Normally soiled crockery. Everyday
cycle, that ensures optimal cleaning and drying performance
in shorter time
6. GLASS - Program for delicate items, which are more
sensitIve to high temperatures, for example glasses and
SILENT - Suitable for night-time operation of the appliance.
Ensures optimal cleaning and drying performance with the
lowest noise emission
SANITIZING - Normally or heavily soiled crockery, with
of the dishwasher, to be carried out only when the
dishwasher is EMPTY using specific detergents designed for
dishwasher maintenance
Notes: Please note that cycle FAST WASH is dedicated for lightly
soiled dishes.
later. No detergent to be used with this program
10. SELF-CLEAN - Program to be used to perform maintenance
additional antibacterial wash. Can be used to perform
maintenance of the dishwasher.
PRE-WASH - Use to refresh crockery planned to be washed
5
cuPS
7
8
9
OPTIONS can be selected directly by pressing the corresponding
button (see CONTROL PANEL).
If an option is not compatible with the selected program see
PROGRAMS TABLE, the corresponding LED rapidly 3 times
and beeps will sound. The option will not be enabled.