Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
10
Daily Use
Check water connection
Check that the dishwasher is connected to the water supply
and that the tap is open.
1
2. Switch on the dishwasher
Open the door and press the ON/OFF button.
3. Load the racks (see LOADING THE RACKS)
4. Filling the detergent dispenser
(see PROGRAMS TABLE).
5. Choose the program and customise the cycle
Select the most appropriate program in accordance with
the type of crockery and its soiling level (see PROGRAMS
DESCRIPTION) by pressing the button.
Select the desired options (see FUNCTIONS).
6. Start
Start the wash cycle by pressing START/Pause button (led
is lit) and closing the door within 4 sec. When the program
starts you hear a single beep. If the door was not closed
within 4sec., the alarm sound will be played. In this case,
open the door, press START/Pause button and close the door
again within 4 sec.
7. End of wash cycle
The end of the wash cycle is indicated by beeps and by the
flashing of the wash cycle number on the display. Open the
door and switch off the appliance by pressing the ON/OFF
button,
Wait for a few minutes before removing the crockery - to
avoid burns. Unload the racks, beginning with the lower one.
The machine will switch off automatically during certain
extended periods of inactivity. in order to minimise
electricity consumption. If the crockery is only lightly soiled
or if it has been rinsed with water before being placed in the
dishwasher, reduce the amount of detergent used
accordingly.
Modifying a running program
If a wrong program was selected, [t is possible to change it,
provided that it has only just begun: open the door, press and
hold the ON/OFF button, the machine will switch off.
Switch the machine back on using the ON/OFF button and select
the new wash cycle and any desired options; Start the wash
cycle by pressing START/Pause button and closing the door
within 4 sec.
Adding extra crockery
Without switching off the machine. open the door (START/
Pause led starts blinking) (be ware of HOT steam!) and place the
crockery inside the dishwasher. Press the START/Pause button
and close the door within 4 sec., the cycle will resume from the
point at which it was interrupted.
Accidental interruptions
if the door is opened during the wash cycle, or if there is a
power cut, the cycle stops. Press the START/Pause button and
close the door wIthin 4 sec., the cycle will resume from the point
at which it was interrupted.
Functions
iIi
e;
CJD
FLEXIBLE WASH
If there are not many dishes to be washed, a half
loading may be used in order to save water, electricity
and detergent.
Select the program and then press the FLEXIBLE
WASH button: the symbol of the chosen rack will
appear on the display.
By default the appliance washes dishes in all racks.
To wash only the specific rack, press this button
repeatedly:
SHORT TIME
This option can be used to reduce the duration of the
main programs while maintaining the same washing
and drying performance levels. After selecting the
program, press the SHORT TIME button and the
indicator light will switch on. To deselect the option,
press the same button again
EXTRA DRY
To improve the drying of the dishes, after selecting
the program, press the EXTRA DRY button and the
indicator light comes on. A higher temperature
during the final rinse and an extended drying phase
allow for improving drying. To deselect the option,
press the same button again. The EXTRA DRY option
results in the lengthening of the wash cycle,
TABLET (Tab)
This setting allows you to optimize the performance
of the program according to the type of detergent
used. Press the START/PAUSE button for 3 seconds
(the corresponding symbol will light up) if you use
combined detergents in tablet form (rinse aid, salt
and detergent in 1 dose).
If you use powder or liquid detergent. this option
should be off,
III
S$S'
b==n=P
I
I
I
I
shown on the display (only lower rack)
shown on the display (only upper rack)
shown on the display (only cutlery rack)
shown on the display (option is OFF and the appliance
will wash dishes in all racks).
©
Remember to load the upper or lower rack only, and to reduce
the amount of detergent accordingly. If upper rack is removed,
please apply detergent directly to tub instead of detergent
dispenser.
DELAY
The start time of the program may be delayed for a
period of time between 1 and 12 hours
1. Press the DELAY button: the corresponding „h"
symbol appears on the display; each arne you press
the button, the time (1h, 2h, etc. up to max. 12h) from
the start of the selected wash cycle will be increased.
2. Select the wash program. press the START/PAUSE
button and within 4 seconds close the door: the timer
will begin counting down
3. Once this time has elapsed, the indicator light <h»
switches off and the wash cycle begins.
To adjust the delay time and select a shorter period
of time, press the DELAY button. To cancel it, press
the button repeatedly until the selected delayed start
indicator light «h» switches off.
The DELAy function cannot be set once a wash
cycle has been started.
re
OPERATION INDICATOR
A LED light projected on the floor indicates that
the dishwasher is working. One of the following
operating modes can be selected:
a) Disabled function
b) When the cycle starts the light goes on for a few
seconds, stays off during the cycle and flashes at the
end of the cycle
c) The light stays on during the cycle and flashes at
the end of the cycle (default mode).
If the delayed start was set, the light goes on either
for the first few seconds or the entire duration of the
countdown, based on whether mode b) or c) was set.
The light goes off every time the door is opened
To select the mode you prefer, switch on the machine,
hold down button a until one of the three letters
Werbung
