Mounting Handgun And Hose Reel; Mounting Of Spare High-Pressure Hose; Mounting Handle; Water Connection - Kärcher HDS Super SX Handbuch

Operating Instructions
Figure 4
Fill with cleaning agent

Mounting handgun and hose reel

! Connect steel pipe (item 15) with
handgun (item 20)
! Insert high-pressure nozzle in union nut
! Mount and tighten unit nut
! Install the hose reel (item31) with the
provided Allen screws, washers and
nuts (4 of each). (Figure 5)
! Install the high-pressure hose at the
high-pressure connection of hose reel
and unit. (Figure 6)
! Connect high-pressure hose of handgun
to hose reel
! Wind high-pressure hose onto hose reel
with the smallest possible bends
(direction of turns - clockwise)
Mounting of spare high-pressure
hose
Figure 7

Mounting handle

Figure 8

Water connection

! For connected loads, refer to Technical
Data.
! Install supply hose at water connection
(item18) of unit.
(supply hose is not part of scope of
delivery)
24
HDS Super SX/HDS 695 SX/HDS 895 SX/HDS 1195 SX

Drawing in water from tank

When you suction water out of an open
container you should
! remove water connection at pump head.
! unscrew the top supply hose to the
water tank and connect it to the pump
head.
! use a water suction hose with a
minimum diameter of 3/4" provided with
a suction filter.
Until the pump sucks up water you should:
! turn the pressure and flow regulation to
MAX.
! close the metering valve for the cleaning
agent.
Warning!
Never suction up water out of a potable
water tank.
Never suction up solvent-bearing liquids
such as paint thinner, benzine, oil or
unfiltered water. The seals in the unit are
not resistant to solvents. The mist of
solvents is highly inflammable, explosive
and poisonous!
English