Maintenance; Maintenance Intervals; Maintenance Tasks; Clean Strainer In Water Connection - Kärcher HDS Super SX Handbuch

Operating Instructions

Maintenance

Warning!
Disconnect unit from mains before carrying
out any maintenance or repair work.
Always use genuine spare parts
Shut off unit before performing any work,
refer to AFTER USE.
! Set the unit switch (item 23) to "0"
! Pull power plug out of socket
! Shut off water supply
! Actuate handgun to depressurise unit.
! Remove water connection
! Allow unit to cool down
Your Kärcher dealer will be pleased to
inform you on the performance of
regular safety inspections
and conclusion of a maintenance
contract

Maintenance intervals

Once a week

— Clean strainer in water connection

— Check oil level
Immediately consult the Kärcher service
station when oil turns milky!
Once a month

— Clean strainer in low water protection

— Clean filter at cleaning-agent suction
hose
After 500 hours of operation, at least
once a year
— Change oil
HDS Super SX/HDS 695 SX/HDS 895 SX/HDS 1195 SX

Maintenance tasks

Clean strainer in water
connection
Figure 11
! Remove strainer
! Clean in water and re-insert
Clean strainer in low water
protection
Figure 12
! Unfasten union nut and detach hose
Figure 13
! Take out strainer
If necessary, screw in screw M8 by
approx. 5mm and pull strainer out with this
screw
! Clean strainer in water
! Slide in strainer
! Mount hose
! Tighten union nut
Clean filter at cleaning-agent
suction hose
Figure 14
! Pull the cleaning agent suction inlet pipe
out
! Clean filter at cleaning-agent suction
hose
! Clean filter in water and re-insert
English
29