Installing The System In The Rack; Installing The Cable-Management Arm; Routing Cables - Dell PowerEdge 2650 Installationsanleitung

Installing the System in the Rack

CAUTION: Due to the size and weight of the system, never attempt to install the
system by yourself.
NOTE: The procedure for installing a system into a rack is identical for flush-mount
and center-mount slide assemblies.
Pull the slides out to their fully extended position.
1
CAUTION: Because of the size and weight of the system, never attempt to install
the system in the slide assemblies by yourself.
Lift the system into position (see Figure 1-17).
2
Place one hand on the front-bottom of the system and the other hand on the back-
3
bottom of the system.
Tilt the back of the system down while aligning the back shoulder screws on the sides
4
of the system with the back slots on the slide assemblies.
Engage the back shoulder screws into their slots.
5
Lower the front of the system, and engage the front and middle shoulder screws in
6
their slots (the middle slot is just behind the yellow system release latch) (see
Figure 1-17).
When all shoulder screws are properly seated, the yellow latch on each slide assembly
clicks and locks the system into the slide assembly.
Press up on the green slide release latch at the side of each slide to slide the system
7
completely into the rack (see Figure 1-17).
Push in and turn the captive thumbscrews on each side of the front chassis panel to
8
secure the system to the rack.
NOTE: Use the yellow system release latch whenever you wish to remove the system
from the slide assemblies.

Installing the Cable-Management Arm

See "Installing the Cable-Management Arm" in "Four-Post Rack Installation" found earlier
in this document.

Routing Cables

See "Routing Cables" in "Four-Post Rack Installation" found earlier in this document.
You have completed the installation of the rack kit in a two-post rack.
Rack Installation Guide
1-27