Installing The Cable-Management Arm - Dell PowerEdge 2650 Installationsanleitung

F i g u r e 1 - 8 .
latch on end of
slide assembly
latch on inner segment
of slide assembly
Install the system status indicator cable plug into its connector (see Figure 1-9).
4
Open the wire covers on the cable-management arm by lifting the center of the wire
5
over the top of the embossed round button on the front of the forward part of the arm
and lifting the wire over the top of a similar round button on the back part of the arm.
The wire cover swings open to enable cables to be routed within the arm.
Route the system status indicator end of the cable through the cable-management
6
arm, and install the indicator in its slot at the back end of the cable-management arm
(see Figure 1-9).
1-14
Rack Installation Guide
I n s t a l l i n g t h e C a b l e - M a n a g e m e n t A r m
tab on front end
tab on back end
cable-management arm