CAUTION: After installing systems in a rack, never pull more than one system
out of the rack on its slide assemblies at one time. The weight of more than one
extended system could cause the rack to tip over and cause injury.
The stabilizer feet help prevent the rack from tipping over when a system or other
component is pulled out of the rack with the slide assemblies fully extended. Refer to the
documentation provided with the rack cabinet for instructions on installing and anchoring
the stabilizer feet.
Recommended Tools and Supplies
You may need the following tools and supplies to install the system in a four-post rack:
•
A #2 Phillips screwdriver (for installing VersaRails slide assemblies)
•
Masking tape or a felt-tip pen, for use in marking the mounting holes to be used
RapidRails Rack Kit Contents
The RapidRails rack kit includes the following items (see Figure 1-1):
•
One pair of RapidRails slide assemblies
•
One cable-management arm
•
One status indicator cable
•
Tie-wraps (not shown in Figure 1-1)
F i g u r e 1 - 1 .
1-4
Rack Installation Guide
R a p i d R a i l s R a c k K i t C o n t e n t s
slide assemblies (2)
status indicator cable
cable-management arm