Necessary Tools; Installation - Sumitomo PARAMAX 9000 Betriebsanleitung

PA R A M A X 9 O p e r a t i n g M a n u a l
4 . Installation of Paramax-Gearbox / Gearmotor

4.1 Necessary tools

- Screw wrench set
- Torque wrench for fastening screws
- Clamp coupling
- Adjusting elements
- Corrosive protection (e.g.. MoS
The anti-corrosive agent used for transportation and storage on the shaftends or hollow shafts,
and on the central seats must be removed before start up. This anti-corrosive agent can be
removed using an alkaline detergent; under no circumstances is it to be removed mechanically
(abrasive etc.). The alkaline detergent must not come into contact with the seals.
When handling lubricants and anti-corrosive agents please observe the respective safety
instructions for people and environment according to DIN 52 900.

4.2 Installation

The drive should be installed so that it is easily accessible for any future lubrication or grease
top up.
First establish a perfect level, using a non-distorting and vibration-absorbing base for the com-
plete mounting area, and align the drive before tightening the fastening screws. Check all fas-
tening screws for correct torque after about 4 weeks.
Dowl pins (e.g. DIN 6325 cylinder pins) are to be used in addition to the base fastening with
screws of property class 10,9 if the drive is being driven to the maximum output torque or max-
imum radial load.
In case of electrochemical corrosion risk due to contact of different metals such as cast iron and
fine steel, plastic protection of 2 or 3 mm thick should go between gear and machine. Screws
should also be protected by plastic discs. In addition, protect the housing with earthing screws
fixed to the motor.
When re-painting the unit, please cover carefully the breather and the shaft seals. Remove any
covering after the painting has been finished.
PX9_DEU_ENG_11_2007_999345
-Paste, Molykote, Copperpaste)
2
Page 7