Daily Inspection And Maintenance - Sumitomo PARAMAX 9000 Betriebsanleitung

PA R A M A X 9 O p e r a t i n g M a n u a l

9. Daily Inspection and Maintenance

Do not handle the unit when connected to the power source. Be sure to turn off the power; pos-
sibly, electric shock may occur. ·
Do not touch any rotating parts (output shaft, etc) during maintenance or inspection of the unit;
loose clothing may become caught in these rotating parts and cause serious injury or death. ·
Customers shall not disassemble or modify explosion-proof type motors ; possibly, explosion,
ignition, electric shock or damage to the equipment may occur. ·
The lead-in condition or an explosion-proof type motors shall conform to the facilities electrical
codes, extension regulations and explosion-proofing guide, as well as the maintenance manu-
al; possible, explosion, ignition, electric shock or damage to the equipment may occur.
Do not put fingers or foreign objects into the opening of the gearmotor or reducer; otherwise,
electric shock, injury, fire, or damage to the equipment may occur. ·
The Paramax drive or reducer is very hot during operation. Touching the unit with bare hands
may cause serious burns. ·
Do not touch the terminal when measuring insulation resistance; otherwise, electric shock may
occur. ·
Do not operate the unit without a safety cover in place to shield rotating parts; otherwise, loose
clothing may become caught in the unit and cause serious injury. ·
Change lubricant according to the maintenance manual instructions. Be sure to use factory rec-
ommended lubricant. ·
Do not change lubricant during operation or immediately after stopping operation; otherwise,
burns may occur. ·
Supply/discharge grease to/from the motor bearing according to the maintenance manual
instructions. Avoid contact with rotating parts; otherwise, injury may occur. ·
Promptly identify and correct, according to instructions in this maintenance manual, any prob-
lems observed during operation. Do not operate until abnormality is corrected. ·
Do not operate damaged Paramax drive or reducers; otherwise, injury, fire or damage to the
equipment may occur. We do not assume any responsibility for damage or injury resulting from
an unauthorized modification by the customer. ·
Dispose PARAMAX DRIVE, or reducer, and lubricant as general industrial waste. ·
When measuring the insulation resistance of an explosion-proof type motor , confirm that there
is no gas, steam or other explosive substance around the unit in order to prevent explosion or
ignition.
PX9_DEU_ENG_11_2007_999345 Page 21