Sumitomo PARAMAX 9000 Betriebsanleitung Seite 60

PA R A M A X 9 O p e r a t i n g M a n u a l
Tab. 18 - Standard Input Speeds
Assembly
Horizontal
Vertical
Upright
Horizontal
Vertical
Upright
Horizontal
Vertical
Upright
Horizontal
Vertical
Upright
Horizontal
Vertical
Upright
Horizontal
Vertical
Upright
Note 1. The ranges except shaded areas show the standard input frequency.
2. Consult us for the ranges exceed the shading areas and the ranges in this table.
3. Consult us for standard frequencies of reducer 9118-9136.
For equipment with motor oil pump, run the pump prior to starting the drive unit or reducer.
Start motor of drive unit or reducer after lubricating oil has circulated through the bearing.
Otherwise, the equipment may be damaged.
Provide flow switch or flow sight to check the circulation of the lubricating oil. Stop the motor of
drive unit or reducer when abnormality occurs.
9.3 Lubrication Maintenance
Tab. 19. Öil change interval
Oil feeding
th
1 Oil change
nd
2 Oil change
Further changes
* whichever comes first.
Please consult lubrication supplier when the atmosphere contains corrosive gas or where
ambient temperature changes dramatically.
PX9_DEU_ENG_11_2007_999345
Size
750
9015 - 9075
9080 - 9085
9095
9105 - 9115
9015 - 9075
9080 - 9085
9015 - 9075
9080 - 9085
9030 - 9095
9100 - 9115
9030 - 9095
9100 - 9115
9030 - 9085
9040 - 9115
9040 - 9115
9040 - 9085
9015 - 9095
9100 - 9105
9110 - 9115
9015 - 9095
9100 - 9105
9110 - 9115
9015 - 9085
9015 - 9115
9015 - 9115
9015 - 9085
9030 - 9115
9030 - 9115
9030 - 9085
Oil change intevall
Before starting up
After 500 hours or 6 months
Every 2,500 hours or 6 months *
Every 5,000 hours or each year *
Every 2,500 hours or 6 months *
Input speed r/min
1000
Operation conditions
Operation with oil temprature < 70°C
Operation with oil temprature > 70°C
1500 1800
-------
-------
-------
Page 23