Sumitomo PARAMAX 9000 Betriebsanleitung Seite 50

PA R A M A X 9 O p e r a t i n g M a n u a l
Removal procedure - Fig. 14
(1) Loosen locking bolt (ZS) and
remove shrink disc (k),
(2) Set thrust washer (D and
hexagon head bolt
(n). Remove the reducer from the
driven shaft using bolt (m).
Note : Parts (d), (e), (f), (ZY), (m), and
(n) are optional.
Order these as required
6.2.2 Key way connection
Sizes 9015 to 9055
The hollow shaft bore is provided with retaining ring (d). Ring (d) is the essential component
for mounting, securing, and removing the unit.
Mounting procedure (Fig. 15)
(1) Smear surface of the shaft (e) with
"molykote 321" or its equivalent.
(2) Turn nut (b) and slide the reducer
over the driven shaft.
Use plain washer (c) if they are
necessary.
Securing (Fig. 16)
(1) After mounting the reducer on the
driven shaft, fix bolt (f).
(Bolt (f) is not supplied with the unit.)
(2) The bore should be protected by
cover (g).
Removal procedure (Fig.17)
(1) Remove ring (d), mount bolt (n), and
reset ring (d).
Attach bolt (J) to ring (d), and turn
bolt (J) to disconnect the hollow
shaft from the driven shaft.
For screw size, refer to table 13
page 16
Special cases (Fig.18)
(1) If the driven shaft has no shoulder
when mounting, provide a distance
ring (h) for fixing in place. (Ring (h) is
not supplied with the unit.)
PX9_DEU_ENG_11_2007_999345
Fig. 14 Removal
( e )
Fig 15
Fig.15
Fig. 16
Fig. 17
Fig. 18
( ZY)
(n) ( f) (m)
( d )
( c)
( b )
( a )
( f)
( g)
( d )
( J)
( n )
( f)
( g )
( h )
Page 13