Disassembly And Assembly - Sumitomo PARAMAX 9000 Betriebsanleitung

PA R A M A X 9 O p e r a t i n g M a n u a l
10. Disassembly / reassembly
Repair, disassembly, and reassembly should be handled by properly trained technicians; oth-
erwise, the system may be damaged.
Keep hands and all foreign objects from keyway and other sharp edges of parts; otherwise,
injury may occur.
· Disassemble them at a clean, dry location.
· Keep accessory parts like screws in the box to prevent loss.
· Carefully handle parts to prevent damage.
10.1 Disassembling / assembling of gear and motor
Fig. 32
Disassembling
Remove mounting bolts
Separate motor from gear reducer
Carefully handle them not to touch the edge of the key and the output shaft end of bushing
and motor, otherwise, coating of bushing may come off.
Mounting
Install gear part to where motor would be easily mounted.
Carefully slide the motor into position in the gear reducer.
Adjust the motor output shaft key to the hollow input shaft keyway.
Apply grease to the motor output shaft and insert carefully into the hollow input shaft.
Carefully handle them not to touch the edge of the key and the output shaft end of bushing
and motor, otherwise, coating of bushing may come off.
Check wether motor is properly inserted and tighten installation bolt to fix motor with flange for
motor.
Disassembling / Assembling of motor
Please pay particular attention to the following when motor is disassembled or assembled.
- Carefully handle bearing and winding not to be adhered with dust and liquid.
- Apply a little bit of adhesive to outer diameter of bearing in the case of overloading usage
such as large loading fluctuations and vibration (Recommended adhesive: Locktite 242 or
271).
- After removing old non-drying liquid gasket, apply new one.
- Make sure that there are no abnormalities by rotating with hands before the trial run.
PX9_DEU_ENG_11_2007_999345
Motor mounting flange
Hollow input shaft
Reducer
Mounting bolt
Motor Motor assembly / disassembly direction
Motor
Page 29