Fitting Transmission Parts; Installing The Gearbox/ Gear Motor; Tools Required; Installation Tolerances On The Gearbox/ Gear Motor - Sumitomo Cyclo Drive 6000 Betriebsanleitung

4. Fitting transmission parts

It is fitted using the centring holes on the shaft ends or by heating the parts to be fitted to a maximum of 100°C.
The shafts are fitted with a groove for feather keys in accordance with DIN 6885, Sheet 1. The holes in parts that
are fitted onto the gear shaft must be made with the tolerances recommended in the relevant product catalogue.
An adjusting screw or similar must be fitted to prevent axial shifting. In order to keep the radial loads low, spro-
cket wheels, discs or gear wheels must be placed as close as possible to the bearing (see picture below). If the
torque is transferred by pinions, chains etc., the drive must be installed in such a way that the gearbox housing is
pushed onto the base-plate. With gearboxes with a hollow drive shaft, MoS2 paste or spray (e.g. molycote) must
be applied to the motor shaft before the counter part is fitted.
Drive parts, such as belt pulleys, couplings etc. must be covered with a guard.
Ex
Any add-on parts must not obstruct the discharge of heat by convection and conduction of heat
Right
Belt pulley
Gearbox
Couplings, discs, gear wheels, chains etc. that are fitted to the gear shafts must not be pressed down or struck to
avoid damage to the bearings.

5. Installing the gearbox/ gear motor

5.1 Tools required

- Spanner set
- Torque wrench for fixing screws to feet/ flange housing, motor lamp, terminal couplings etc.
- Mounting device
- Compensating tools
- Corrosion protection (e.g. Mos2 paste)

5.2 Installation tolerances on the gearbox/ gear motor

Drive shafts
Drive shafts
Hollow shaft in
the drive
Centring holes as per DIN 332, DR shape

5.3 Checks before starting installation

- Data on the model plate must agree with the existing documentation such as drawings, parts lists, etc.
- The power data of any existing motor must match that of the mains power supply.
- The drive must not be damaged in any way.
- The lubricants provided must be suitable and if necessary prepared for the environmental conditions.
22
D6000_DEU_ENG_01_2010_2.0_991179
Wrong
Belt pulley
Gearbox
Shafts
k6 for ø < 30 mm
h6 for ø > 30 mm
k6 for ø < 50 mm
h6 for ø > 50 mm
F7
E-Mail: marktind@sce-cyclo.com
www.sumitomodriveeurope.com Phone +49 (0) 8136 66 0
Drive 6000 Operating Manual
Right-angled and parallel
Right
Flanges
Spigot tolerance as per DIN 42948
IEC flange on the drive side
Flange on the output side
Housing for F type
Wrong
H8
j6
up to size 612
f8
from size 613
g6
Cyclostraße 92
85229 Markt Indersdorf