Scheppach deco-flex Original Bedienungsanleitung Seite 28

16. Troubleshooting
WARNING
Always switch the machine off and remove the mains plug prior to all maintenance and cleaning work.
Fault
Saw blade without pins
loosens after switching off
the engine
Motor does not start
Saw blades brake
Saw blade oscillates, not
aligned straightly.
28 | GB
Possible cause
Saw blade clamping screw (28/29)
not tightened enough
Failure mains fuse
Extension cable defect
Fine-wire fuse defective
Connections on the motor or switch
defect
Motor or switch defect
Tension set incorrectly
Load too high
Incorrect saw blade type
Workpiece not fed straightly
Holders not aligned
www.scheppach.com
Remedy
Tighten the saw blade clamping screw (28/29)
Check the mains fuse.
Change extension cable.
Check the fine-wire fuse and, if necessary, replace
it with a fine-wire fuse of the same type.
Have it checked by an electrician.
Have it checked by an electrician.
Set correct tension
Feed workpiece more slowly
Use correct saw blades
Avoid lateral pressure
Open the screws that fasten the holders. Bring the
holders into the vertical position and tighten the
screws again.