Scheppach deco-flex Original Bedienungsanleitung Seite 27

13. Cleaning, maintenance and
ordering of spare parts
WARNING
Always switch the machine off and remove the mains
plug prior to all maintenance and cleaning work.
13.1 Cleaning
Keep all safety devices, air vents and the motor hous-
ing free of dirt and dust as far as possible. We recom-
mend that you clean the equipment immediately after
you use it.
13.1.1 Exterior cleaning
• Clean the equipment regularly with a damp cloth
and some soft soap.
• Do not use cleaning agents or solvents; these may
be aggressive to the plastic parts in the equipment.
• Ensure that no water can get into the interior of the
equipment.
13.2 Servicing
13.2.1 Bearings (fig. 15)
Lubricate the bearing points of the deflection rollers
after approx. 25-30 operating hours at the latest us-
ing high-quality machine grease.
13.2.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
IMPORTANT
The carbon brushes should not be replaced by any-
one but a qualified electrician.
13.2.3 Mains cable
If the mains cable is pulled out, cut, or damaged in
some other form, then it should be replaced imme-
diately.
13.3 Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: Carbon brushes, saw blade, table inlay
* Not necessarily included in the scope of delivery!
13.4 Ordering replacement parts
The following information must be provided on all or-
ders for spare parts:
• Type of the product
• Article number of the product
14. Storage
Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing tem-
perature. The ideal storage temperature is between 5
and 30 °C. Store the power tool in its original packag-
ing.
15. Disposal and recycling
The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be re-
used or recycled.
The equipment and its accessories are made
of various types of material, such as metal
and plastic. Defective components must be disposed
of as special waste. Ask your dealer or your local
council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of waste
equipment may have negative consequences for the
environment and human health due to potentially
hazardous substances that are often contained in
electrical and electronic equipment. By properly dis-
posing of this product, you are also contributing to the
effective use of natural resources. You can obtain in-
formation on collection points for waste equipment
from your municipal administration, public waste dis-
posal authority, an authorised body for the disposal of
waste electrical and electronic equipment or your
waste disposal company.
www.scheppach.com
GB | 27