Adjust Cutting Height - Murray Mu-Bat-Lm37-Kit Bedienungsanleitung Und Garantiekarte

User manual and warranty card
• battery fully charged: red, orange and green leds are lit,
• partially charged battery: red and orange leds are lit,
• battery needs recharging: red led lights up.
STARTING THE MOWER
• Ensure that the batteries 12 (Fig. 9) are correctly installed.
• Insert the plastic key 15 (Fig. 9) into the ignition switch.
• Close the battery cover 11 (Fig. 1).
• Press and hold the on/off button 1 (Fig. 10).
• Press and hold the switch lever 2 (Fig. 10) in the direction of handle 3 (Fig. 10) at the
same time.
• Release the on/off button 1 (Fig. 10).
To turn off the device:
• Release switch lever 2 (Fig. 10).
Warning!
When the appliance is switched off, the blade rotates for a few seconds. Do not touch the
moving blade with a relative risk of injury.

ADJUST CUTTING HEIGHT

Warning! When the engine is running, the knives rotate. Disconnect the mower from
the power supply before changing the cutting height.
The cutting height is adjusted using the lever on the side of the mower.
To lower the cutting height, move the lever in the direction of the arrow Fig. 11.
To mow the grass slightly higher, move the lever in the opposite direction.
EMPTY THE GRASS BASKET
Warning! Switch off the mower and remove the starter key before emptying and
removing the basket.
Basket full indicator (Fig. 12) allows for quick assessment of the level of filling of the basket.
If the indicator plate is raised while the mower is operating, the basket is not full yet.
If the indicator plate is horizontal when the mower is operating, the basket is full and must
be emptied.
 Lift the basket cover and remove the grass container.
 Empty the Recycle Bin and reinstall it.
NOTE: If grass is not required to be picked up in the basket, the mower can be used without
the basket, with the safety guard in the down position. Do not mow grass with the flap
raised without the basket in place.
24
English