Murray MU-BAT-LM37-KIT Bedienungsanleitung Und Garantiekarte Seite 23

User manual and warranty card
ATTENTION! Do not charge a hot battery. After the charging process, let the battery
cool down completely.
ATTENTION! Check the appliance before charging. Do not charge a cracked or leaking
battery.
ATTENTION! Always make sure you are using a genuine and compatible battery
before charging. Do not attempt to charge a battery that does not fit the charger.
Once the battery has been charged and cooled down, it can be inserted into the mower and
started to work with the equipment.
To charge the battery:
 Connect the charger (Fig. 6) to a power outlet. The green LED lights up. (POWER ON in
Fig. 6)
 Insert the battery into the charging dock, the red LED lights up to indicate that the
charging process has started. (CHARGING in Fig. 6)
 When the green LED lights up, the battery is fully charged. (FULL charge in Figure 6)
ATTENTION! The battery may become hot during the charging process, this is normal,
but in this case you must wait before installing the battery to the appliance until it cools
down.
*Expected operating time of the device with batteries of different capacities:
The battery
20V 3.0 Ah
20V 4.0 Ah
*the estimated operating time cannot be determined precisely, because it depends on
factors such as: intensity of use, ambient temperature, time between charging the battery
and its use.
For your comfort, it is recommended to purchase an additional battery (the same or
higher capacity) to extend the operating time of the device without major interruptions
to recharge the battery.
CHECK THE BATTERY CHARGE STATUS
The battery charge status can be checked by pressing the button on the panel located on the
handle of the mower (Fig. 8)
The battery charge level is indicated by the corresponding LEDs on the battery charge status
indicator (Fig. 8):
MU-BAT-LM37-KIT
Two batteries
45 min.
60 min.
23
Working time
MU-BAT-LM43-KIT
Two batteries
37 min.
50 min.
English