Kessel EasyClean ground NS 1 Einbau- Und Betriebsanleitung Seite 32

Filling with cold water
Start cold water supply.
Wait until the water level has reached the static level
and then stop cold water supply.
Re-insert the cover plate.
Record the disposal in the log book.
Disposal procedure is completed.
Carry out disposal (Direct version)
Open the service access cover during pumping off.
Connect the suction hose of the disposal vehicle to the
Storz-B coupling.
Start the pumping process at the disposal vehicle.
Wait until 1/3 of the static level has been pumped off.
How long this takes depends on the nominal size.
Clean the inside walls of the tank (as far as required)
while pumping off
At the same time as the pumping out process, clean the
inside walls of the tank with a water hose.
Once the tank has been pumped empty (slurping
noises) , end the pumping off process by the disposal
vehicle.
Disconnect the suction hose of the disposal vehicle from
the Storz B coupling.
32 / 108
,
Installation and operating instructions 010-298E