Storage; Troubleshooting; Error Correction - Parkside Performance Ppwsfa 20-Li C4 Originalbetriebsanleitung

GB MT

Storage

Always store the device and ac-
cessories:
• clean
• dry
• protected against dust
• In the case provided (29)
• out of the reach of children
Devices with battery:
• The storage temperature for the
battery and device is between 0 °C

Troubleshooting

The following table will assist you in fixing faults:
Problem
Device does not start
Attachment tool does not
move although motor is
running
Engine is slowing down
and stops
Attachment tool does not
rotate smoothly, abnormal
noises can be heard
Device works with inter-
ruptions
50
and 45 °C. Avoid extreme cold
or heat during storage to ensure
the battery output is not adversely
affected.
• Remove the battery from the
device before storage over a longer
period (see separate operating in-
structions for battery and charger).
Storing cutting/grinding discs
• dry
• upright
• unstacked
Possible cause
Rechargeable battery (22)
not inserted
On/Off button (15) defect-
ive
Defective motor
Clamping nut (26) loose
Workpiece, workpiece
remnants or remnants of
attachment tools blocking
the drive
Device is overloaded
through workpiece
Clamping nut (26) loose
Attachment tool defective Changing the attachment
Internal loose contact
On/Off button (15) defect-
ive

Error correction

Inserting the battery,
p. 47
Contact the service
centre.
Contact the service
centre.
Tightening the clamping
nut
Remove blockages
Reduce pressure on at-
tachment tool
Workpiece unsuitable
Tightening the clamping
nut
tool
Contact the service
centre.