Adjusting The Speed; Switching On And Off; Parkside App - Parkside Performance Ppwsfa 20-Li C4 Originalbetriebsanleitung

GB MT
2. Turn the guard cover (5) into the
desired position.
3. Let go of the release lever (31).
4. Move the guard cover (5) a little
until it clicks into place.

Adjusting the speed

You can adjust the speed at any time
during operation. Use the speed but-
ton (14) to select the desired level.
Rough guide for speed selection:
level Attachment
tool
2-3 Cup brush
4-6 Grinding disc
6 Grinding disc
6 Cutting disc

Switching on and off

Notes
• Depending on the intended use,
observe the working instructions
for the device (Working instruc-
tions, p. 46).
• When the guard cover is fitted, ad-
just it so that the smallest possible
part of the grinder is facing the op-
erator. Readjust the guard cover if
necessary.
Switching on
1. Press the Unlock button (13).
The charge level indicator (11) in
the control panel lights up.
2. Select a suitable speed. You can
adjust the speed at any time dur-
ing operation.
3. Switch on: Press the On/Off but-
ton (15) twice in quick succession.
48
Application
Brushing,
coarse rust re-
moval, paint re-
moval
Sanding/Grind-
ing
Roughing
Cutting
4. Check that the attachment tool is
running smoothly. If not: Replace
the attachment tool.
5. Wait until the device has reached
full speed.
6. Guide the attachment tool against
the workpiece.
Switching off
1. Remove the attachment tool from
the workpiece.
2. Switch off: Press the On/Off but-
ton (15) or the Unlock button (13).
The charge level indicator (11) in
the control panel goes out.
3. Wait until the power tool has
stopped before placing it down.
4. If you are leaving the device un-
attended or if you have finished
working: Remove the battery (22)
from the device.

PARKSIDE app

The PARKSIDE app lets you monitor
the device and control certain func-
tions. The functions may change with
updates to the app and firmware. For
more information on the PARKSIDE
app, see the instructions for the smart
battery.
Requirements
To find the device in the PARKSIDE
app, the following requirements must
be met:
• The PARKSIDE app is installed on
your smartphone and Bluetooth®
is activated.
• The device contains the following
battery: PARKSIDE Performance
Smart battery Smart PAPS 204 A1/
Smart PAPS 208 A1/
Smart PAPS 2012 A1. This battery
is already connected to the
PARKSIDE app.