Parkside Performance PPWSFA 20-Li C4 Originalbetriebsanleitung Seite 40

GB MT
procedures or conditions and can be
avoided by taking proper precautions
as given below.
• Maintain a firm grip with both
hands on the power tool and
position your body and arms
to allow you to resist kickback
forces. Always use auxiliary
handle, if provided, for maximum
control over kickback or torque
reaction during start-up. The op-
erator can control torque reactions
or kickback forces, if proper pre-
cautions are taken.
• Never place your hand near the
rotating accessory. Accessory
may kickback over your hand.
• Do not position your body in the
area where power tool will move
if kickback occurs. Kickback will
propel the tool in direction oppos-
ite to the wheel's movement at the
point of snagging.
• Use special care when working
corners, sharp edges, etc. Avoid
bouncing and snagging the ac-
cessory. Corners, sharp edges or
bouncing have a tendency to snag
the rotating accessory and cause
loss of control or kickback.
• Do not attach a saw chain wood-
carving blade, segmented dia-
mond wheel with a peripher-
al gap greater than 10 mm or
toothed saw blade. Such blades
create frequent kickback and loss
of control.
Safety warnings specific for
grinding and cutting-off operations
• Use only wheel types that are
specified for your power tool
and the specific guard designed
for the selected wheel. Wheels
for which the power tool was not
designed cannot be adequately
guarded and are unsafe.
40
• The grinding surface of centre
depressed wheels must be
mounted below the plane of the
guard lip. An improperly moun-
ted wheel that projects through the
plane of the guard lip cannot be
adequately protected.
• The guard must be securely at-
tached to the power tool and po-
sitioned for maximum safety, so
the least amount of wheel is ex-
posed towards the operator. The
guard helps to protect the operat-
or from broken wheel fragments,
accidental contact with wheel and
sparks that could ignite clothing.
• Wheels must be used only for
specified applications. For ex-
ample: do not grind with the side
of cut-off wheel. Abrasive cut-off
wheels are intended for peripher-
al grinding, side forces applied to
these wheels may cause them to
shatter.
• Always use undamaged wheel
flanges that are of correct size
and shape for your selected
wheel. Proper wheel flanges sup-
port the wheel thus reducing the
possibility of wheel breakage.
Flanges for cut-off wheels may
be different from grinding wheel
flanges.
• Do not use worn down wheels
from larger power tools. A wheel
intended for larger power tool is
not suitable for the higher speed of
a smaller tool and may burst.
• When using dual purpose wheels
always use the correct guard for
the application being performed.
Failure to use the correct guard
may not provide the desired level
of guarding, which could lead to
serious injury.