Safety Information For Angle Grinders - Parkside Performance Ppwsfa 20-Li C4 Originalbetriebsanleitung

GB MT
haviour resulting in fire, explosion
or risk of injury.
f) Do not expose a battery pack or
tool to fire or excessive temper-
ature. Exposure to fire or temper-
ature above 130 °C may cause ex-
plosion.
g) Follow all charging instructions
and do not charge the battery
pack or tool outside the temper-
ature range specified in the in-
structions. Charging improperly or
at temperatures outside the spe-
cified range may damage the bat-
tery and increase the risk of fire.
6. SERVICE
a) Have your power tool serviced
by a qualified repair person us-
ing only identical replacement
parts. This will ensure that the
safety of the power tool is main-
tained.
b) Never service damaged battery
packs. Service of battery packs
should only be performed by the
manufacturer or authorized service
providers.
Safety information for angle
grinders
Safety warnings common for
grinding, wire brushing and
cutting-off operations
• This power tool is intended to
function as a grinder, wire brush
or cut-off tool. Read all safety
warnings, instructions, illustra-
tions and specifications provided
with this power tool. Failure to
follow all instructions listed below
may result in electric shock, fire
and/or serious injury.
• Operations such as sanding, pol-
ishing or hole cutting are not to
be performed with this power
tool. Operations for which the
38
power tool was not designed may
create a hazard and cause person-
al injury.
• Do not convert this power tool
to operate in a way which is not
specifically designed and spe-
cified by the tool manufacturer.
Such a conversion may result in a
loss of control and cause serious
personal injury.
• Do not use accessories which
are not specifically designed and
specified by the tool manufac-
turer. Just because the access-
ory can be attached to your power
tool, it does not assure safe opera-
tion.
• The rated speed of the access-
ory must be at least equal to the
maximum speed marked on the
power tool. Accessories running
faster than their rated speed can
break and fly apart.
• The outside diameter and the
thickness of your accessory
must be within the capacity rat-
ing of your power tool. Incorrectly
sized accessories cannot be ad-
equately guarded or controlled.
• The dimensions of the access-
ory mounting must fit the dimen-
sions of the mounting hardware
of the power tool. Accessories
that do not match the mounting
hardware of the power tool will run
out of balance, vibrate excessively
and may cause loss of control.
• Do not use a damaged access-
ory. Before each use inspect
the accessory such as abras-
ive wheels for chips and cracks,
backing pad for cracks, tear
or excess wear, wire brush for
loose or cracked wires. If power
tool or accessory is dropped, in-
spect for damage or install an