Fitting The Filter Cover; Removing The Appliance - Gaggenau Ac250121 Gebrauchs- Und Montageanleitung

en Installation instructions

Fitting the filter cover

WARNING ‒ Risk of injury!
Components inside the appliance may have sharp
edges.
Wear protective gloves.
Risk of injury when opening and closing the hinges.
Keep your hands away from the hinges.
Open the hinges on the filter cover.
1.
25
Mount the filter cover on the designated screws and
2.
push it backwards/forwards depending on the key
hole opening into the narrow section.
Tighten the fastening screws on the hinges.
3.
40
Check whether the appliance frame is lying flush.
4.
5
Retighten the screws if necessary.
Fit the grease filters.
5.
To avoid causing damage, do not bend the grease fil-
ters.
Swing the filter cover up and ensure that it engages.
6.

Removing the appliance

WARNING ‒ Risk of injury!
The appliance is heavy.
To move the appliance, two people are required.
Use only suitable tools and equipment.
Components inside the appliance may have sharp
edges.
Wear protective gloves.
Risk of injury when opening and closing the hinges.
Keep your hands away from the hinges.
Disconnect the appliance from the power supply.
1.
Swing down the filter cover.
2.
Open the filter cover fully and without pulling on it.
Remove the grease filters.
3.
To avoid causing damage, do not bend the grease fil-
ters.
Press together the cable duct at the sides and re-
4.
move it.
Disconnect the cable at the appropriate point.
5.